User Manual

Basic Operation
RoboSHOOT
©
User’s Manual Page 5
FCC Compliance
The RoboSHOOT
©
units including MX-20, MX-15, RX-20, ad RX-15 comply
with FCC standards for Home and Office use.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference
that may cause undesired operation.
FCC WARNING
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
 Reorient or relocate the receiving antenna.
 Increase the separation between the equipment and the
receiver.
 Connect the equipment into an outlet different from that to
which the receiver is connected.
 Consult the dealer or an experienced radio/TV technician for
help.
 You are cautioned that any modification, misuse, or use of
untested cable may void the user’s authority to use this
equipment.