User Manual

Smartphone App Operation
RoboSHOOT
©
User’s Manual Page 31
TTL requested power can be overridden by adjusting
the Master knob. This always affects overall flash
exposure when any knobs are in TTL mode and a
ready speedlight is assigned to that group.
The left side indicators are similar to the flash ready
on your speedlight, except they indicate ready for
the entire group.
At the bottom third of the page you find controls for
Flash Enable, Overall TTL Power Offset, Flash
Exposure Lock, TTL Flash Test, and Shutter Release.
Profile tray and zoom controls may or may not be
visible, according to the settings. By default, neither
is shown. To modify the settings click the settings
icon in the upper right corner.
Zoom controls, if visible, allow you to set the
speedlight zoom for each group. It can be set as a
specific mm value or as a multiple of the current lens
setting. This gives you finer control over your subject
illumination.
The profile tray allows you to select and edit profiles,
which may be used individually or for bracketing.
MX-20