Installation and Operation Guide

Pre-Installation - continued
Contents of packaging: Typical equipment required:
1 x rangehood electric drill and screwdriver
1 x packet of fasteners and wall plugs tape measure and spirit level
2 x chimney pieces (upper and lower) step ladder
1 x chimney bracket duct tape (if ducting)
1 x Installation and Operating Instructions jig saw (if ducting)
ladder (if ducting)
Ducting Options
The method of ducting should be carefully considered before installing the rangehood. The guide below recommends
the ducting kit to use for all common ducting configurations - through the top of the home (for the roof and soffit) and
through the rear of the home. 150mm round ducting should be used in conjunction with this model rangehood.
Alternatively this rangehood can be operated in recirculation mode (Pg.6 Recirculation mode).
The highlighted area in the table below gives the recommended Uniduct Kit numbers for different
mounting and outlet options.
Extra lengths and/or bends may be required, depending on the length required and whether there is any structural
material in the way, e.g. rafters.
Please note that this chart is designed as a guide. Please consult Robinhood customer services if unsure.
For NZ phone [phone] or www.robinhood.co.nz. For AUS phone [phone] or www.robinhood.com.au.