Installation & Assembly

539
ASSEMBLY INSTRUCTIONS FOR YOUR
BOND OUTDOOR CHANDELIER
ASSEMBLY INSTRUCTIONS:
1. SHUT OFF MAIN ELECTRICAL SUPPLY FROM THE MAIN FUSE BOX/CIRCUIT BREAKER.
2. Remove all parts from carton and discard packing materials. Place the parts on a protected work surface.
3. Remove mounting plate (A) from canopy (E) by removing screws (D). Set screws (D) aside.
4. Place the mounting plate (A) against the mounting surface so it is aligned with the ceiling outlet box. Once
aligned, check to make sure that the position of the mounting plate is straight. When the proper placement has
been conrmed, use a pencil to mark the locations of the mounting plate support holes (B) onto the mounting
surface.
5. Set the mounting plate aside and drill small holes at the marked locations. Holes should be sized so anchors
(M), provided, t securely inside.
6. Push anchors (M) into holes.
7. Carefully pull the wiring from the ceiling outlet box. Thread the wires through the center hole in mounting
plate (A).
8. Ax mounting plate (A) to outlet box with mounting screws (C) provided.
9. For additional support, thread mounting screws (L) through holes (B) and into wall anchors (M).
10. Measure desired drop for xture to hang and add/remove chain links (H) with chain break tool (not
included).
11. Secure quick link (G) to hang straight (F). Repeat for remaining chain.
12. Secure quick link (I) to loop (J). Repeat for remaining chain.
13. Guide wire exiting the xture through chain (H), quick link (G), through the center of the hang straight (F),
and up through the hole in the canopy (E).
14. Cut the cord to the desired length to make electrical connections. Note: At least 8 inches of wire is needed to
make proper electrical connections.
15. Lift canopy (E) to mounting plate (A) and make proper electrical connections described in steps 15-17. A
LICENSED ELECTRICIAN IS RECOMMENDED.
16. Attach ground wire from the xture (green or copper in color) to the ground wire in outlet box. Fasten wires
together with wire nut (N) and tightly wrap connection with electical tape.
17. Attach hot wire from xture (black in color, or smooth side of wire) to hot wire from ceiling outlet box.
Fasten wires together with wire nut (N) and tightly wrap connection with electrical tape.
18. Attach neutral wire from xture (white in color or ribbed side of wire) to neutral wire from ceiling outlet
box. Fasten wires together with wire nut (N) and tightly wrap connection with electrical tape.
19. Gently push wire conections back into ceiling outlet box. Slide canopy (E) over mounting plate (A). Thread
screws (D) into holes in canopy (E) to secure xture to ceiling.
20. Install seven 60W MAX. Type B, candelabra base bulbs into sockets (K).
21. Reconnect main electrical suppy from the fuse box/ circuit breaker and test the xture.
IMPORTANT SAFETY INSTRUCTIONS:
* These instructions are provided for your safety.
* It is very important that they are read completely before beginning the installation of your xture.
* WE STRONGLY RECOMMEND INSTALLATION BY A LICENSED ELECTRICIAN.
* Turn o power at switch before replacing bulbs, making sure xture has had sucient time to cool down.
* This xture is UL rated for wet locations.
** To clean, use soft cloth only. Do not use any chemical or abrasive cleaners. **