Installation Guide

ASSEMBLY INSTRUCTIONS FOR YOUR
WILLIAMSBURG TUCKER CHANDELIER
308
ASSEMBLY INSTRUCTIONS:
1. SHUT OFF THE MAIN ELECTRICAL SUPPLY AT THE FUSE BOX/ CIRCUIT BREAKER.
2. Remove all parts carefully from the carton. Do not throw away any parts.
3. Place the fi xture on a level surface. Begin assembly by attaching the fi xture to the lower canopy.
4. Attach the bottom of the extension arm to the fi xture frame by placing hook (O) into loop (P) as shown in Illustration A. Thread
screw (N) completely into hook (O) to secure the extension arm to the fi xture frame. Attach the top of the extension arm to the lower
canopy by placing loop (M) over hook (L). Repeat steps for remaining support arms.
5. Disconnect hang straight (E) from chain (G) by removing quick link (F). Keep cross bar (B), threaded tube (C), canopy (H), and
collar (I) together.
6. Measure desired drop for fi xture to hang and add/remove chain links with chain break tool (not included). Reattach quick link (F) to
the top link of chain (G).
7. Connect the bottom of chain (G) to loop (K) using quick link (J). Thread the wires exiting loop (K) through the links in chain (G).
8. Unthread collar (I) from hang straight (E). Slide the collar down over the electrical wires and chain (G) so it sits on loop (K).
9. Slide canopy (H) down over the electrical wires and chain (G) so it sits on top of collar (I).
10. Thread wires exiting the top of chain (G) through the center of hang straight (E) and threaded tube (C). Attach hang straight (E) to
the top of chain (G) using quick link (F).
11. Cut the cord to the desired length to make electrical connections. At least 8” of wire will be needed to make proper electrical
connections. Lift the fi xture to the ceiling and attach cross bar (B) to the outlet box using mounting screws (D).
12. Make proper electricial connections described in steps 13 - 15. A LICENSED ELECTRICIAN IS RECOMMENDED.
13. Attach ground wire from the fi xture (green or copper in color) to the ground wire in outlet box. Fasten wires together with wire nut
(A) and tightly wrap connection with electrical tape.
14. Attach hot wire from fi xture (black in color, or smooth side of wire) to hot wire from ceiling outlet box. Fasten wires together with
wire nut (A) and tightly wrap connection with electrical tape.
15. Attach neutral wire from fi xture (white in color or ribbed side of wire) to neutral wire from ceiling outlet box. Fasten wires
together with wire nut (A) and tightly wrap connection with electrical tape.
16. Carefully push wire connections back into ceiling outlet box. Slide canopy (H) up chain (G) and hold fi rmly against ceiling. Slide
collar (I) up chain (G) and thread onto hang straight (E) to secure the canopy in place.
17. Insert six 60W max, type B, candelabra base bulbs into the sockets.
18. Reconnect main electrical supply at fuse box/ circuit breaker and test the fi xture.
* To clean fi xture, wipe with soft cloth. Do not use any chemical or abrasive cleaners. *
IMPORTANT SAFETY INSTRUCTIONS:
*These instructions are provided for your safety. It is very important that they are read completely before beginning the installation of
your fi xture.
*WE STRONGLY RECOMMEND INSTALLATION BY A LICENSED ELECTRICIAN.
*Turn off power at switch before replacing bulbs
*If any special control devices are used with this fi xture, follow the instructions carefully to assure full compliance with N.E.C.
requirements. If there are any questions, contact a qualifi ed electrical contractor.