Installation Guide
8
© 2017 Robern, Inc. 701 N. Wilson Ave. Bristol, PA 19007 U.S.A.
800.877.2376 www.robern.com
Installation instructions
Part no. 209-1274-rA rev. 06/06/17
Curated Cartesian H2
STEP 5 - SINK ASSEMBLY
1. Thread the screws [203-1335] into the brackets [210-1100] and thread the acorn nuts [203-1337] onto the screws. Place the
assembled brackets into the vanity opening(s). Brackets should be snug and ush to the top of the vanity.
2. Place the sink(s) into the opening(s) and position the sink(s) at the front of the vanity. Test t the stone top to be sure the sink(s) is
properly located.
3. Apply a 1/4" (6mm) bead of silicone sealant on both vanity and sink ange(s).
4. Carefully place the stone top on the vanity and sink. Note: The back edge of the stone top must be ush against the wall and equal
left and right overhang on each side of the vanity.
3
4
1 2