Installation Guide

800.877.2376 www.robern.com

Installation instructions

Part no. 209-1274-rA rev. 06/06/17

Curated Cartesian H2

STEP 1 - PREP THE WALL

There are two types of electrical options available for vanities. The rst is a night light option ordered with the vanity. The second is an

electrical accessory [VAELECTRIC]. Both of these options can be plugged into the same outlet.

The outlet must be wired to a 120vac 20 amp GFCI circuit. We do not recommend using a GFCI outlet because resetting it under the

vanity will be inconvenient.

The night light has no switch. A switch can be wired to one receptacle in the outlet to operate the night light or, for a seamless

experience, an occupancy sensor can be installed near the doorway to the bathroom.

All applicable electrical codes in your area must be followed.

The outlet can be installed to the left or right of center depending on which side the VAELECTRIC accessory will be located.

Plumbing should be located as shown to prevent interference with the vanity drawers.

Supply

11-3/16"

(284 mm)

Drain

11-5/8"

(295 mm)

(178 mm)

5-1/8" (130 mm)

Plumbing drawer clearance

(203 mm)