Specifications

23
Focu C - ne calibration of focus
Focu V - version of mechanical focus (should be set once more if
the light source has been changed).
Focu H - setting of focus hysteresis (should be set once more if
the light source has been changed).
Store - saves adjusted values into memory
Cal Col - Calibration of white colour and gamma curve.
Red C - a red saturation setting
Green C - a green saturation setting
Blue C - a blue saturation setting
Gamma C - a gamma setting
Store - saves adjusted values into memory
Calibration of pan/tilt/focus via the control board.
1. Disconnect DMX controller from the xture and enter the "Calib" menu.
2. Enter the "Cal PTF" menu.
3. Use the [PREV] and [NEXT] to nd "Pan" and press [ENTER].
4. Set desired value and save it by pressing [ENTER].
5. Repeat steps 3 and 4 for tilt and focus.
6. After calibrating all effects, nd item "Store" and press [ENTER]. to save all adjusted values and reset the
xture.
Calibration of white colour.
1. Disconnect DMX controller from the xture and enter the "Calib" menu.
2. Enter the "Manual" menu, open shutter and dimmer and set "Cyan", "Magen" ,"Yellow", "Virt C" items to 0.
3. Enter the "Cal Col" menu. By means of the Red, Green and Blue items adjust the 8000K colour temperature
as exactly as possible (∆u´v´= 0).
4. After calibrating, nd item "Store" and press [ENTER]. to save all adjusted colours and reset the xture
Hori Align - Digital calibration of the RGB LED device. This function allows digitally
"align" RGB LED device in the xture head in case, that it is placed askew.
Sw Upd - Graphical software update. The item starts update of the graphical software in the xture.
Insert the USB ash drive with update le into USB port, select this option and press [ENTER]. Version of the
new software will be displayed, eg, v 003 ?.
If you want to run update, press [ENTER] again.
FW Upd - Firmware update. The item starts update of hardware functions like pan, tilt,focus...etc. and should
be performed after graphical software update
To perform software update of the xture
1. Connect the MiniMe to the mains.
2. Plug the USB ash drive into the xture.
3. Initialize the USB ash drive (via menu "Init USB") and unplug it.
4. Plug the USB ash drive into computer.
5. Download update le from Robe website into your computer.
Note: Please make sure the full name of the update le is minime_vxxx.tar.gz
(vxxx=version number) before you upload it into the USB ash drive.
6. Upload update le into folder (update) and unplug it.
7. Plug the USB ash drive back into the MiniMe.
8. Run graphical software update via menu "Sw Upd".
9. Run rmware update update via the menu " FW Upd" (if the notice " Do Fw Upd " appeared)