User Manual

4 Adjustments

Figure 4.3 Figure 4.4

ADJUSTING THE BRAKES

Adjusng Linear Pull Brakes

Aaching the Brake Cable to the Brake Carrier

❶ Squeeze the two brake arms together unl the brake pads

touch the wheel rim. Figure 4.3

❷ With your other hand, pull on the brake cable and insert the

end of the “noodle” into the brake carrier.

Adjusng the Brake Pads

❸ Check the brake cable is seated in the brake lever. Using a

5 mm Allen wrench loosen the cable anchor bolt enough so

the brake cable can move freely. Figure 4.4

❹ Pull the brake cable through the cable anchor so the

le brake arm moves towards the rim and there is

approximately a 1/8” (3 mm) gap between the brake

pad and rim.

❺ Move the right brake arm towards the rim unl there is

approximately a 1/8” (3 mm) gap between the brake pad

and rim.

❻ Using the 5 mm Allen wrench, rmly ghten the cable

anchor bolt completely.

Failure to properly set the brakes may result in the inability

to stop the bicycle movement and cause serious injury or

death. Be sure the brakes are funconing properly before

using the bicycle.

WARNING!

Cable anchor bolt

Wheel rim

5 mm Allen wrench

1/8” gap

(both pads)

Brake carrier

End of “noodle” in

the brake carrier

Brake arm

Brake cable

Brake arm