Operator's Manual WE ARE HUNTERS TWOPLEX 2-Man Ladder Stand MODEL RE665 Maximum Height 17' 1” to shooting rail Maximum Field Rating 500 lbs; no more than 300 lbs per person. Tree Diameter Range 12" to 20" Wear Your Harness! PRODUCT MEETS INDUSTRY STANDARDS RECOGNIZED BY Get parts online at www.HuntRiversEdge.
Operator's Manual TWOPLEX 2-Man Ladder Stand INTRODUCTION Rivers Edge® Treestands are engineered with you the hunter in mind. We appreciate your purchase of one of our world class treestands. Follow these few simple instructions and your stand will provide you many years of trouble-free pleasure. Instructions should be kept in a safe place and reviewed at least annually.
Operator’s Manual TWOPLEX 2-Man Ladder Stand STOP READ AND UNDERSTAND THE FOLLOWING WARNINGS BEFORE ASSEMBLY MODEL RE665 MAXIMUM USE HEIGHT - 17' 1” TO SHOOTING RAIL MAXIMUM OCCUPANCY - TWO (2) PEOPLE TOTAL WEIGHT LIMIT - 500 LB (300 lb Per Person Max) TREE DIAMETER RANGE - 12” TO 20” WARNING This product carries strict height and weight restrictions. Do Not use this product if you exceed the total weight limit. Please note that the total weight limit includes the user(s) and their equipment.
Operator's Manual TWOPLEX 2-Man Ladder Stand WARNING INSPECTION AND MAINTENANCE Always lean forward as you climb and attach your harness to the tree before securing the platform to the tree and stepping onto the platform. Never exceed the stated maximum use height. Do Not use this product until you have watched the safety video, understand it, and practiced the techniques for safe hunting discussed in this video.
Bolts shown are for size reference. Extra hardware may be included in the parts bag.
Operator’s Manual TWOPLEX 2-Man Ladder Stand ASSEMBLY INSTRUCTIONS IMPORTANT ASSEMBLY TIP: Do not tighten any nut and bolt combinations completely until all parts are assembled together! Finger tighten plus one turn of a wrench only! This will temporarily hold the lock nut on the bolt while helping alignment of all parts! After all parts are assembled together, all nut & bolt combinations must be completely tightened. All assembly must be done in this order at ground level before uprighting.
Operator's Manual TWOPLEX 2-Man Ladder Stand 8 7 17 29 25 FIGURE 3 25 4. Attach left (7) and right (8) seat supports to platform sections (6) using four 1/4-20 x 2-1/4 IN bolts (27) and locknuts (29). SEE FIGURE 3. 5. Attach platform braces (17) to platform section (6) and both left (7) and right (8) seat supports using four 1/4-20 x 1-1/2 IN bolts (25) and locknuts (29). SEE FIGURE 3. 27 NOTE: Be sure seat supports are installed correctly as shown in FIGURE 3. 29 6 Mesh hidden for clarity 8 6.
Operator’s Manual TWOPLEX 2-Man Ladder Stand 8 31 29 7 FIGURE 5 19 30 21 8. Secure rear of the Teartuff seat assembly (31) to left (7) and right (8) seat supports using two 1/4-20 x 2-3/4 IN bolts (30), yellow plastic washers (21), plastic spacers (19) and locknuts (29). SEE FIGURE 5. NOTE: Be sure hardware is oriented as shown in FIGURE 5. 9 27 Check for parts online at www.HuntRiversEdge.com or call 800-345-6007 29 FIGURE 6 9.
Operator's Manual TWOPLEX 2-Man Ladder Stand 10 11 FIGURE 7 26 29 NOTE: Flipping seat up during Step 10 will make it easier to install top tree blade (11) into seat support (10). 15 28 14 FIGURE 8 11. Attach a shooting rail insert (14) to each end of shooting rail (15) using a 1/4-20 x 1-1/4 IN bolt (28) and locknut (29) on each side. SEE FIGURE 8. 10.
Operator’s Manual TWOPLEX 2-Man Ladder Stand 30 23 7 FIGURE 9 22 15 21 8 12. Install M6 knobs (23) and M6 bolt (22) onto left (7) and right (8) seat supports. SEE FIGURE 9. 19 13. Attach shooting rail assembly (14 and 15) to left (7) and right (8) seat supports using two 1/4-20 x 2-3/4 IN bolts (30), yellow plastic washers (21), plastic spacers (19) and locknuts (29). SEE FIGURE 9. NOTE: Be sure hardware is installed as shown in FIGURE 9. Depth of the shooting rail is also adjustable at this time.
Operator's Manual TWOPLEX 2-Man Ladder Stand FIGURE 11 17. Ladder sections are assembled on the ground in the following order: bottom ladder section (4), middle ladder section (3) and the top ladder section (2) with the treestand top assembly. Connect all sections together using the six lockpins (20). SEE FIGURE 11. 2 20 3 4 ground 18. Attach stabilizer support tube (18) to the bracket on the middle ladder section (3) using a lockpin (20). SEE FIGURE 12. 3 1 FIGURE 12 19.
Operator’s Manual TWOPLEX 2-Man Ladder Stand FIGURE 13A 12 39 FIGURE 13B FIGURE 13 20. Attach the two long ends of the 16’ criss-cross straps (39) to the bottom tree blade (12). These long stabilizer straps should be attached by pulling the free end of the strap through the loop end of the strap to create a cinch knot around the frame tube. SEE FIGURES 13A AND 13B. 12 39 Check for parts online at www.HuntRiversEdge.
Operator's Manual TWOPLEX 2-Man Ladder Stand STOP READ AND UNDERSTAND THE FOLLOWING WARNINGS BEFORE SETUP AND USE WARNING WARNING Double check assembly steps to be certain you have correctly assembled this product. Study your new stand to become familiar with all of its features and design. At ground level, following provided use instructions, practice attaching stand to tree and re- moving stand from tree. Practice sitting, standing, and using this product before attaching overhead.
Operator’s Manual TWOPLEX 2-Man Ladder Stand SETUP AND USE INSTRUCTIONS During installation and removal of ladder treestands, you must always and properly use the included Full Body Harness (Fall Arrest System). Refer to the Full Body Harness instructions included with this product for proper use. 1. Select a straight, healthy tree. Do Not attempt to install on a tree that is not healthy. 2.
Operator's Manual TWOPLEX 2-Man Ladder Stand 10. Make sure the criss cross straps and stabilizer bar strap are snug and the tree blades are still both contacting the tree. B NOTE: This ground level ladder-to-tree attachment will prevent the ladder from pulling away from the tree while ascending to the top for final two 6’ ratchet straps (38) attachment. The same holds true when the ladder is removed. C 11.
Operator’s Manual TWOPLEX 2-Man Ladder Stand FINISHED LADDER RATCHET STRAP PADDED FLIP-BACK SHOOTING RAIL RATCHET STRAP PLATFORM CRISS CROSS STRAPS STABILIZER BAR CAM STRAP LOCKPIN LADDER ATTACHMENT STABILIZER BAR Check for parts online at www.HuntRiversEdge.
Operator's Manual TWOPLEX 2-Man Ladder Stand ILLUSTRATED PARTS BREAKDOWN 9 30 23 27 21 29 25 29 30 31 8 21 22 24 21 19 27 28 13 29 26 19 19 19 11 10 14 15 24 17 7 25 30 27 29 6 20 27 1 3 12 5 18 20 25 16 29 26 25 4 29 2 20 18 Check for parts online at www.HuntRiversEdge.
Operator’s Manual TWOPLEX 2-Man Ladder Stand PARTS LIST ITEM # PART # DESCRIPTION QTY.
WE ARE HUNTERS Rivers Edge® Treestands, Inc. Phone: 800-345-6007 1730 Industrial Avenue, PO Box 755 Fax: 715-822-2124 Cumberland, WI 54829 www.HuntRiversEdge.com *All weights, specifications and features are approximate and are subject to change without notice. Due to continuous product improvements, product images may not be exact. Warning labels in some product images may have been removed for photography purposes only. Props shown in photos not included. Some assembly may be required.
