User's Manual
Table Of Contents
- XS-3900 User’s Guide
- Front Matter
- Table of Contents
- List of Figures
- Introduction
- Installing the XS-3900
- Installation Prerequisites
- Planning Your Installation
- Installation Workflow
- Unpacking the XS-3900
- Installing the XS-3900
- Powering Up the XS-3900
- Establishing Communication with the Array
- Performing the Express Setup Procedure
- The Web Management Interface
- Configuring the XS-3900
- Logging In
- Making Configuration Changes to the XS-3900
- Array Status
- Express Setup
- Network Interfaces
- IAP Interfaces
- SSID Management
- Security
- Users
- Services
- Software
- Tools
- Event Log
- The Command Line Interface
- Establishing a Secure Shell (SSH) Connection
- Basic Commands
- Command Modes
- Selecting Interfaces
- Command Line Keywords
- Interface Selection
- Interface Configuration
- Radio Configuration
- Beacon Information
- System Administration
- System Testing
- Security
- Station Timeouts
- SSID Configuration
- DNS Configuration
- NTP Configuration
- DHCP Configuration
- Syslog Configuration
- SNMP Configuration
- Filters
- Radius Configuration
- Reports
- Data Handling
- Data Clearance
- Show Information
- Remove Configuration
- Help
- Appendix A: Quick Reference Guide
- Appendix B: Technical Support
- Glossary of Terms
- Index
Wireless LAN Array
64 Configuring the XS-3900
8. Wireless Security: Select the desired wireless security scheme (WEP or
WPA). Make your selection from the choices available in the pull-down
list.
WEP (Wired Equivalent Privacy)
An optional IEEE 802.11 function that offers frame transmission
privacy similar to a wired network. WEP generates secret shared
encryption keys that both source and destination stations can use to
alter frame bits to avoid disclosure to eavesdroppers.
WPA (Wi-Fi Protected Access)
A Wi-Fi Alliance standard that contains a subset of the IEEE 802.11i
standard, using TKIP or AES as an encryption method and 802.1X for
authentication. WPA is the stronger of the two wireless security
schemes.
For more information about security, including a full review of all
security options and settings, go to“Security Management” on page 98.
9. Wireless Key/Passphrase: Depending on the wireless security scheme
you selected, enter a unique WEP key or WPA passphrase.
a. Confirm Key/Passphrase: If you entered a WEP key or WPA
passphrase, confirm it here.
10. New Admin Password: If desired, enter a new administration password
for managing this array. Choose a password that is not obvious, and one
that you can remember. If you forget your password, you must reset the
array to its factory defaults so that the password is reset to admin (its
default setting).
a. Confirm Admin Password: If you entered a new administration
password, confirm the new password here.
11. Adjust Time (hrs:min:sec): Check this box if you want to adjust the
current system time. When the box is checked, the time fields become
active. Enter the revised time (hours, minutes, seconds, am/pm) in the
corresponding fields. If you don’t want to adjust the current time, this
box should be left unchecked (default).