Instructions / Assembly

Page 1 of 2
Instructions - 3GEN Battery Box
Hanging Lamp (outdoor)
*DUAL POWER OPERATION- You may use this item with Batteries or Plug-in with the provided adapter.
PARTS
Battery Box
(pre-installed in lamp canopy)
Remote Control
Adapter
Wire
Batteries
AC IN 120V
Output 5V
3 x “C”
Batteries
(not included)
1 x “A23”
For Remote
Control
(not included)
Bulb – it has been pre-installed in the item, the LED Bulb included will last for tenths of thousands of hours, not
replaceable.
BATTERIES Operation
1. The Battery Box has been pre-installed inside the Lamp Canopy as shown
2. Reach into the Canopy and Open the Battery Box Lid removing the three thumb
screws indicated in the diagram. You may use a coin to turn the screws. Slide the
Lid up to access the compartment.
3. Install the three “C” batteries (not included) ensuring to follow the polarity signs.
4. Place the Lid back in place securing the three thumb screws (ensure the rubber
seal on the perimeter of the battery box compartment is in place before securing
the lid).
WARNING – Do not submerge the Battery Box in water. Although the box was
designed to withstand outdoor environments it is NOT recommended for
extreme weather conditions.
CAUTION – Ensure the Lead wire of the Battery Box is covered with the provided rubber cover while the
Battery Box is operated with batteries. The cover will protect the Lead wire connection points.
PLUG-IN Operation
Connect the Battery Box Lead wire to the Adapter securing the threaded terminals. Ensure you align the terminals
properly, look for a small slot in the connector to match them properly.