Owner's Manual

To program an alternate or "Special Day" program, that you can access at any

time, press day> until PROGRAM FOR for SDP DAY is displayed. Repeat

the procedure above to program temp settings for the Special Day.

When finished programming, press HOME to save your program.

To program for cooling,

select COOL with the Heat/Cool MODE switch and repeat the above procedure.

To REVIEW the program you have entered.

Press PROGRAM once to enter Programming Mode.

Then, press FILTER / REVIEW once,

The display will cycle through the programmed times and temps, showing each

program for 12 seconds. Starting from Sunday; P1 and ending at Saturday; P4.

The programmed temperature is shown on the left of the LCD, the programmed

time, day and time slot are shown on the right and right top of the LCD

respectively.

Press HOME to leave program REVIEW mode and run the program.

3 Program cont.

Select the time of day you want that TIME SLOT to represent:

To set the time when P1 will begin, press the <TIME or TIME> buttons to

move the set point forward or backward in time.

Select the next TIME SLOT and program temp and time:

Press NEXT>, the display will show P2, for Period 2. Repeat setting temp and

time. Select the remaining TIME SLOT's, P3 and P4. Program their temp and

time info.

Repeat the above procedures for each day of the week. Push DAY> button

to cycle through the days.

To COPY the program of the current day to another day, press COPY

program once. COPY will display on the LCD. The day icon for the source

day will go solid and the day icon for the destination day will flash. Use the

day> button to select the destination day.

Press COPY again to confirm the copy. If you decide you don't want to copy,

press HOME to exit.

TIMETIME

DAY

PG 5

PG 6