Owner's Manual

PG 1
Statement of use: The GPMG8099 can be used with most
24 volt gas, oil or electric heating systems, or gas millivolt
heating systems. It cannot be used with 120 volt heating
systems or heat pumps.
Configure
Set HEAT/COOL mode switch to HEAT or
COOL. Set the Fan switch to automatic.
Once you have installed the thermostat,
follow the instructions below to operate your
new thermostat.
Your thermostat is now in operation.
In the winter, set the system switch to HEAT to control
your heating system.
In the summer, set the system switch to COOL to
control your air conditioner.
In spring and fall or when windows are open, you can
set the system switch OFF.
Setting the FAN switch to AUTO automatically runs your
system's fan during heating and cooling.
Setting the FAN switch to ON runs your system's fan
continuously even without heating or cooling.
NOTE: LED blinks when batteries are low.
Caution: System will stop when batteries die.
Set Temp
Operate
Turn the Temperature dial to select the desired temperature.
Warmer - counter clockwise (red)
Cooler - clockwise (blue)
Temperature
Dial
HEAT/COOL
Mode Switch
Low Battery
indicator
Fan
Switch
COOLER
WARMER
Customer Support: 888-515-2585
Visit our webiste www.ritetemp.info
Operation 6008