Motion Sensor Smart Lighti ng
Download the Ring app. 1 The app walks you through setting up and managing your Motion Sensor. Download it on your iOS or Android device.
Set up your Ring Bridge. The Bridge connects your Ring Smart Lights to the Ring app and other compatible Ring devices. To set up your Bridge, follow the instructions in the Ring app or Bridge user manual.
Remove the front cover. Pull the tabs on the sides outward until you can remove the front of your Motion Sensor. Insert the batteries. Insert three AAA batteries (not included), matching the flat ends with the . springs.
Set up your Motion Sensor in the Ring app. In the app, tap Set Up a Device. When prompted, select Smart Lights and follow the in-app instructions. Once setup is complete, you can replace the front of your Motion Sensor. 0 ........ ~ s« Up• 0.V•c• tb Sm.vtUgllu ,.
2. Insta your Motion Sensor. Remove the base. Slide the base down to remove it from your Motion Sensor. If installing on a masonry surface, use the base as a template to mark pilot holes. Drill the holes and insert the anchors. 0 j Your Motion Sensor works best when mounted 4-6 feet above the ground.
Drive the screws. Hold the base firmly against the surface and drive the two mounting screws. Attach the Motion Sensor. Then slide your Motion Sensor back onto its base until it clicks into place.
For additional help, visit: ring.com/help Or give us a call. .. us 1800656 1918 Canada 1 855 300 7289 Worldwide +1 310 929 7085 For a list of all our customer support numbers, visit: ring.com/callus To review your warranty coverage, please visit www ring.com/warranty. Patents: www.rmg.com/patents © 2019 Ring LLC or its affiliates. Ring, Alexa, Always Home, and all related logos are trademarks of Amazon.com, Inc. or its affiliates.
1. Download the Ring app. Open the app, tap Set Up a Device, then select Smart Lights. 2. Scan this code. This identifies your Ring to make setup fast and easy. ~ 81 CJ To review your warranty coverage, please visit www.ring .com/ warranty. Patents: www.ring com 'patents © 2019 Ring LLC or ,ts affiliates. Ring, Alexa, Always Home, and all related logos are trademarks of Amazon com, Inc. or its affiliates.
• ring 1 523 26th St. Santa Monica, CA 90404 Models: Ring Motion Sensor (C20), Ring Spotlight (C30), Ring Steplight (C40), Ring Pathlight (CS0), Ring Floodlight Battery (C3500), Ring Floodlight Wired (CS000), Ring Transformer (CT200) Canada CAN ICES-3 (B)/NMB-3(6) Innovation, Science and Economic Development Canada (ISED) Compliance. This device contains license-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada's license-exempt RSS(s).
However, there is no guarantee that int,e rference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver.
