Installation Instructions

1-Load your gear into the dry bag. Place sharp edged

items in the middle and softer items around them.

4-Tightly roll the top of the bag downward until it contacts

your gear (Fig 2). Make sure the top of the bag is rolled a

minimum of (3) times to make the bag waterproof. Remove

extra gear if over packed.

5-Bring the ends of the bag together and engage the

quick release buckle (Fig 3).

Fig 1 Fig 2

6-Repeat steps 1 – 5 for the second strap.

Pack The Dry Bag(s)

2-Squeeze the bag to force out excess air.

Fig 4 Fig 5

Fig 8 Fig 9

Fig 3

2-Wrap the long strap piece around the rear of the hitch

rack, thread its end through its loop, and pull tight (Fig 6).

1-Unthread the short strap piece from the buckle, wrap it

around the front of the hitch rack, thread its end through

its loop, and pull tight (Fig 4 and Fig 5).

Hitch Rack Dry Bags 100T62

www.rightlinegear.com/setup.html

Set Up

Video:

CODE

Fig 6 Fig 7

3-Lift a bag onto your hitch rack. (2) bags will sit side-by-

side on most hitch racks (Fig 7).

The correct attachment of this product is critical and

beyond the control of Rightline Gear. The safe use and

long life of this product depends entirely on your good

judgment and following these directions.

4-Run the long strap piece over the top of the dry bag.

Adjust its length by moving the tri-glide (Fig 8).

5-Thread the short strap piece back through the center

buckle (Fig 9) and tighten (Fig 10).

7-Repeat steps 1 – 6 for the second dry bag.

Attach The Dry Bag(s) To A Hitch Rack

Fig 10

Tri-glide

3-Hold the two webbing strips at the top of the bag

together (Fig 1).

Each of the (4) included straps has (2) strap pieces

connected through a center buckle.

PAGE 1
Attach The Dry Bag(s) To A Hitch Rack Each of the (4) included straps has (2) strap pieces connected through a center buckle. Hitch Rack Dry Bags Set Up Video: QR CODE 100T62 1-Unthread the short strap piece from the buckle, wrap it around the front of the hitch rack, thread its end through its loop, and pull tight (Fig 4 and Fig 5). www.rightlinegear.com/setup.html Fig 4 The correct attachment of this product is critical and beyond the control of Rightline Gear.
PAGE 2
Attach The Dry Bag(s) To A Truck Bed 1-Lift the bag(s) into your truck bed (Fig 11). Position the bag(s) standing up (Fig 12) or laying down (Fig 13 and Fig 14). 2-Decide how you will run the straps over or around the dry bag(s). Each of the (4) included straps has (2) strap pieces connected through a center buckle. Fig 15 5-Run the long strap piece over or around the dry bag(s). Adjust its length by moving the tri-glide (Fig 16).