User's Manual

3. Loosen the two screws and remove the cover of the Wireless LAN interface board installation

unit.

BFL055S

The removed cover is not used when installing the interface board.

4. Fully insert the Wireless LAN interface board.

BFL058S

5. Tighten the two screws to secure the interface board.

Check the Wireless LAN interface board is connected firmly to the controller board.

• Confirm that the interface board was correctly installed by printing the configuration page. If it is

correctly installed, "Wireless LAN" will appear for "Device Connection" on the configuration page.

• If the board was not installed properly, repeat the procedure from step 2. If it cannot be installed

correctly even after reattempting installation, contact your sales or service representative.

• For details about printing the configuration page, see "Test Printing", Quick Installation Guide.

• Before using the Wireless LAN interface board, you must configure settings from the printer control

panel. For details, see "Wireless LAN Configuration".

• p.70 "Wireless LAN Configuration"

Installing the Interface Units