User's Manual
• You can press the [Escape] key to exit to the previous level of the menu tree.
• If 2-sided scanning is specified, you must use the ARDF (scanning will not be possible with the
exposure glass).
• You can change the machine's default [Original] setting to always scan specific sides of originals.
• Temporary job settings are cleared in the following cases:
• When no input is received for the period of time specified in [System Auto Reset Timer] while
the initial screen is displayed.
• When the [Clear/Stop] key is pressed while the initial screen is displayed.
• When the machine's mode is changed.
• When the power is turned off.
• When the machine's default for the same setting is changed.
• For details about [Original], see p.265 "Scanner Settings".
• For details about [System Auto Reset Timer], see p.301 "Administrator Settings".
5. Using the Scanner Function
194 rinmei-mf2_com_user_guide_gb_00059731_eng.xml
5
No.104【ソフトキーOriginal】(FWv0.24)
ソフトキーのOriginalで読み取り面の設定ができますが、スキャナーの場合はあて先に
すでに登録されています。
①アドレス帳から宛先を指定した後にソフトキーのOriginalを押下しても操作できませ
んでした。一時的に設定を変更することはできないでしょうか。
②ScantoUSB操作の場合は操作が有効でした。ソフトキーのOriginalはScantoUSB
のときに使うキーでしょうか。
③スキャナー初期設定のOriginalの設定は、ScantoUSB実行時に影響する項目でし
ょうか(他のプッシュスキャン操作はあて先の設定に依存するため)。
Draft 2011/08/29