Operations Manual

Revision 9/21
14190 E. Jewell Avenue Suite 4 Aurora CO 80012 TEL: [phone]
www.rfidinc.com
13.56 MHz High Frequency Reader Operations Manual
14
Tag Data = Response
<CR> = Carriage Return
or
Reader Response: <LF>e<CR>
Where: <LF> = Line Feed
e = Response indicating no Tag is present
<CR> = Carriage Return
Version Request Command - [I]
This command request the Reader’s firmware version.
Host: [I]
Where: I = command
Reader Response: <LF>Version 1.08<CR> (example)
Where: <LF> = Line Feed
Version 1.13 = firmware version
<CR> = Carriage Return
ISO Protocol Switch Command - [B]
This command will cycle through the different ISO protocols supported by the Reader, each
time it’s used it responds with the resulting ISO protocol.
Host: [B]
Where: B = command
Reader Responses: <LF>15693<CR>
<LF>14443-A<CR>
<LF>14443-B<CR>
<LF>ICODE1<CR>
Where: <LF> = Line Feed
15693 = ISO protocol
<CR> = Carriage Return
ISO15693 Commands
Read Page – [RXX] Where XX = Page number
Enter the R command followed by a two digit page number (example 05).
Host: [R05]
Where: R05 = command
Reader Responses: <LF>05 00000578<CR>
<LF>e<CR>
Where: <LF> = Line Feed
05 00000578 = page address and data held in that page
<CR> = Carriage Return
A response if “e” signifies the command failed or Tag is not present to Reader