User's Manual

Help Command
Help displays the commands followed by its data type and expected syntax. The table below displays
the Help command output. The functions display in blue.
Help Command Summary
rfid:beep.now rfid:disp.fac.hex
‡ rfid:cfg rfid:disp.fac.send
‡ rfid:cfg.card.hipri rfid:disp.fac.strip
‡ rfid:cfg.card.list (Function) rfid:disp.hex.lower
‡ rfid:cfg.card.type rfid:disp.id.digits
rfid:cfg.read (Funtion) rfid:disp.id.hex
rfid:cfg.reset (Function) rfid:help (Funtion)
rfid:cfg.write (Function) rfid:op.beep
rfid:chr.1 rfid:op.cont
rfid:chr.2 rfid:op.sdk
rfid:chr.3 rfid:out.led
rfid:chr.count.lead rfid:qid (Function)
rfid:chr.count.trail rfid:qid.hold
rfid:chr.eol rfid:qid.id
rfid:chr.fac rfid:qid.id.hold
rfid:chr.gone.1 rfid:time.hold
rfid:chr.gone.2 rfid:var (Function)
rfid:cmd.echo rfid:wieg.id.bits
rfid:cmd.prompt rfid:wieg.inv.bits
rfid:dev.luid rfid:wieg.qual
rfid:dev.part (Function) rfid:wieg.qual.bits
rfid:dev.ver (Function) rfid:wieg.rev.bits
rfid:disp.64bit rfid:wieg.rev.bytes
rfid:disp.fac.64bit rfid:wieg.strip.lead.bits
rfid:disp.fac.digits rfid:wieg.strip.trail.bits
‡ Applies only to the pcProx Plus
Command Data Type R, W, R/W Definition
rfid:beep.now
INT W Sounds the beeper immediately up to 5 short
beeps or 2 long beeps.
beep.now variables:
1 – single short beep
2 – two short beeps
3 – three short beeps
4 – four short beeps
5 – five short beeps
101 – single long beep
102 – two long beeps
50 Chapter 4 ASCII Command Protocol