User's Manual

22
Note: When using the red ‘End Call’ button while another caller is on hold, that caller will
remain on-hold in the telephone network. The FLX2 Conference Phone will not be able to
retrieve that call.
Charging Components during a Call
Each system component will respond differently when placed in or out of the charger
during an active telephone call. The following is a description of what can be expected.
Dialer
When the Dialer is placed into the Charger Base during a call in ‘speaker mode’, the call
will not be affected and the Dialer will enter its charging mode.
When the Dialer is placed into the Charger Base during a ‘handset mode’ call, the call
will end and the Dialer will enter its charging mode.
When the Dialer is removed from the Charger Base no change to call activity will take
place. If there is no active call, the Dialer will revert to the home screen.
<<< Add a picture of the home screen >>>
Speaker
When the Speaker is placed into the charger during a call the Speaker will reboot and
enter its charging mode. During the reboot the incoming audio from the conference call
will mute until the reboot is complete (Approximately 6 seconds). Once the reboot is
complete the audio will resume on the speaker.
When the Speaker is removed from the charger no change to call activity will take
place.
Microphones
When a Microphone is placed into the charger during a call it will automatically mute
and enter its charging mode. If all Microphones are placed into the charger during a
speaker call, all microphones will mute and will need to be manually un-muted. It is not
recommended to use the microphones in the charger tray for a speaker call.
If at least one Microphone is outside the charger base active, the Microphone in the
Charger Base cannot be unmuted.
When a Microphone is removed from the charger, it will automatically power on and if
“Start Unmute” is ON, unmute itself. If there is an incoming call when a Microphone is
removed from the charger the call will automatically be answered.