C263, C283, C363XC, C383XC In-Ceiling Architectural Loudspeaker Instruction Manual
DOCUMENTATION CONVENTIONS This document contains general safety, installation and operation instructions for the Revel® C283, C263, C383XC, and C363XC inceiling loudspeakers. It is important to read this document before attempting to use this product. Pay particular attention to: WARNING: Calls attention to a procedure, practice, condition or the like that, if not correctly performed or adhered to, could result in injury or death.
LOUDSPEAKER PLACEMENT FOR DISTRIBUTED SOUND • Since distributed sound is general sound throughout an area, place the loudspeakers as uniformly as possible for even sound coverage throughout the area. • Place the left and right loudspeakers roughly the same distance from the primary listener locations. • To avoid “hot spots” where the sound is too loud, plan to use more loudspeakers, with each set to play at a lower volume.
INSTALLATION INSTRUCTIONS CONNECTING TO THE AMPLIFIER CAUTION: Do not use the tweeter-mounting baffle as a handle to move, carry or position the speaker. Doing so can damage the baffle. Such damage is not covered by the speaker’s warranty. CAUTION: REMOVE POWER You must connect the speaker wires before the speaker is fully installed.
MOUNTING THE SPEAKERS For New Construction If you wish to pre-install a rough-in frame for the speakers before the drywall is installed in new construction, you will need to purchase the correct rough-in frame kit for your loudspeaker model from your authorized Revel dealer. Detailed mounting instructions are supplied with the rough-in kit. After the drywall is installed, follow the installation instructions in For Existing Construction, below. 4.
7. Insert the speaker straight into the mounting opening. Tighten the speaker-clamp screws on the front of the speaker baffle. The speaker clamps will automatically rotate into position and begin clamping the speaker. • When you notice resistance on the screws, the speaker has been clamped successfully. IMPORTANT: Always use low-torque settings.
DIMENSIONS Mounting Opening Diameter Mounting Depth Overall Dimensions (w/grille) C283 9-5/8" (244mm) 5-1/8" (130mm) 10-23/32" (272mm) Dia. x 5-5/16" (135mm) Deep C263 8" (203mm) 4-23/32" (120mm) 9-3/32" (231mm) Dia x 4-15/16" (125mm) Deep C383XC 9-5/8" (244mm) 2-3/4" (70mm) 10-23/32" (272mm) Dia. x 2-31/32" (75mm) Deep C363XC 8" (203mm) 2-11/16" (69mm) 9-3/32" (231mm) Dia. x 2-15/16" (74mm) Deep Dimensions are subject to change without notice.
LIMITED WARRANTY Revel speakers are warranted against defects. The duration of a speaker’s warranty depends on the laws in the country in which it was purchased. Your local Revel retailer can help you determine the length of your warranty. HARMAN International Industries, Incorporated 8500 Balboa Blvd., Northridge, CA 91329 © 2012 HARMAN International Industries, Incorporated. All rights reserved.
REVEL EXTREME C CLIMATE FLUSH-MOUNT LOUDSPEAKERS ®
REVEL EXTREME CLIMATE LOUDSPEAKERS ® -N KNMFDQ LTRS XNT R@BQHjBD RNTMC PT@KHSX HM SGD M@LD NE CTQ@AHKHSX @MC RSXKD 3GD 7" 2DQHDR BNLAHMDR 1DUDK R @V@QC VHMMHMF RNTMC @MC CDRHFM VHSG CTQ@AHKHSX SG@S RTQUHUDR SGD SNTFGDRS DKDLDMSR /DQEDBS ENQ HMCNNQ @MC NTSCNNQ KNB@SHNMR @MC @MXOK@BD SG@S HR GNS BNKC C@LO GTLHC NQ VDS SGD RG@KKNV CDOSG 7" kTRG LNTMS LNCDKR jS ITRS @ANTS @MXVGDQD 1DUDK R TMNASQTRHUD 9DQN ADYDK L@FMDSHB@KKX @SS@BGDC FQHKKDR CDKHUDQ NM RSXKD VHSG @ KNNJ SG@S @KKNVR SGD ROD@JDQR
MODERN LOOK AND FUNCTIONAL DESIGN 1DPTHQHMF KDRR SG@M HMBGDR LL LNTMSHMF CDOSG SGD " 7" @MC " 7" OQNUHCD @M HCD@K HMRS@KK@SHNM RNKTSHNM HM @OOKHB@SHNMR VGDQD CDOSG HR @ BNMBDQM 9DQN ADYDK L@FMDSHB FQHKKDR NEEDQ @ LNCDQM CDRHFM @MC DKDF@MS @OOD@Q@MBD 3GD L@QHMD FQ@CD HMBG LL @MC HMBG LL QNTMC $WSQDLD "KHL@SD FQHKKDR @QD HCDMSHB@K HM @OOD@Q@MBD SN SGD QDRS NE SGD 1DUDK QBGHSDBSTQ@K HM V@KK @MC HM BDHKHMF LNCDKR OQNUHCHMF BNGDRHUD @DRSGDSHBR SGQNTFGNTS SGD GNLD 6HSG A
SPECIFICATIONS C363XC C383XC » 6-1/2" (165mm) Aluminum Cone, Cast-polymer frame woofer » 8" (200mm) Aluminum Cone, Cast-polymer frame woofer » 1" Aluminum dome tweeter with phase ring » 1" Aluminum dome tweeter with phase ring » Mounting depth: 2.72" (69.1mm) » Mounting depth: 2.69" (68.3mm) » Weight: 3.1 lb (1.41kg) / Shipping weight: 4.6 lb (2.1kg) » Weight: 3.9 lb (1.8kg) / Shipping weight: 5.9 lb (2.
LIMITED WARRANTY United States, US Territories – Effective January 1, 2017 This limited warranty (this “Limited Warranty”) protects only the original end-user (“you” or “your”), and is not transferable. Any attempt to transfer this Limited Warranty shall immediately make this Limited Warranty void.
