User's Manual

OEM Installation Instructions

The RE926S module is installed in the GE SimonXT host as follows:

1. The SimonXT panel should be powered down, with battery unplugged.

2. Open the panel and expose the back.

3. Unwrap the module from its packaging and carefully slide the module underneath the

plastic tabs at the top of the expansion slot.

4. Gently press down on the bottom of the module so that it engages with the connector on

the panel.

5. Secure the module in place using four screws in the corner holes.

6. Before closing up the back of the panel, reconnect the battery and power up the panel.

7. Locate the wireless router or access point and press the WPS button.

8. Press the WPS button on the RE926S until the Wifi LED starts flashing red.

9. Wait up to 1-2 minutes until a connection is made and the Wifi LED stays lit red and stops

flashing.

10. Close the back cover of the panel.

11. Connect to the module using the configuration IP address and configure the module's IP

addresses and other information with the configuration interface.

12. The above picture shows the correct installation of the RE926S in the back of the SimonXT.

RE926S Wifi Module User Manual Page 3 of 5