Use and Care Manual


Installation Instructions Tempered Glass vessel Sinks
Suggested Tools Needed:
Step 1
Drill 1-3/4 in. hole on countertop.
Allow for adequate clearance under
the countertop for faucet supply lines,
drain assembly & any structural
parts of the cabinet. Provide a 2 in.
minimum clearance between the
back of the sink & the back of the countertop.
Countertop diagram is for reference only.
Step 2
Place mounting ring,
washer & glass vessel as shown.
We recommend applying a silicone
caulk bead both above & under the
mounting ring to reduce vibration.
Step 3
Connect trap to drain assembly (as shown).
If necessary cut off part of the tailpiece
or part of the horizontal leg pipe
to complete installation.
Putty knife & putty or caulking
Tape measure
Adj. slip lock nut
wrench
Tubing cutter or hacksaw
Drill
Screw driver
Supplies as needed
1-1/4” O.D.
Waste
6-1/4”
7-1/4”
8”
5-1/4”
5-1/2”
2” min.clearance
Horizontal Leg
Tailpiece
To avoid scratching
do NOT use
a wrench with serrations (teeth)
Washer
Mounting Ring
Silicone
Caulk bead

Summary of content (3 pages)