User's Manual

M306NKT3-RPD-E User’s Manual 2. Setup
REJ10J0326-0400 Rev.4.00 Sep. 01, 2006 Page 47 of 104
2.9.5 Jumper Switches JP1 and JP2 on he M30620T3-PRT (MCU-dependent board 1)
Table 2.5 Switch settings of the M306NKT3-RPD-E (3)
Signal Switch Setting Description
A18_SEL
1M
JP1
4M
(factory-settings)
Always use this setting.
A18_SEL JP1
A18_SEL
1M
JP1
4M
Do not use this setting.
VDDIO
VCC1 VCC2
JP2
VCC1>VCC2
=
(factory-settings)
Always use this setting.
VDDIO JP2
VDDIO
VCC1 VCC2
JP2
VCC1>VCC2
=
Do not use this setting.
CAUTION
Note on Switch Settings:
 Always shut OFF power before changing switch setting.