User's Manual
Table Of Contents
- WELCOME
- INTRODUCTION
- Optional Accessories
- External Speaker/Microphone
- External VOX Headset
- Battery Packs
- FCC REQUIREMENTS
- SAFETY PRECAUTIONS
- Dealer Programmable Options
- Before Using Your Radio
- Battery Installation and Removal
- Antenna Installation and Removal
- Radio Views
- Aurora Radio Controls
- Front View
- Display
- Backlight
- Keypad
- Speaker
- Top View
- Status Indicator
- On/Off Volume Knob
- Squelch Knob
- Programmable Three-Position Switch
- Emergency Button
- Channel Selector Knob
- Side Views
- PTT Switch
- Programmable Softkey Buttons
- Options Connector
- Basic Operation 23
- TRANSMIT
- Code Guard Operation
- Code Guard Receive
- Code Guard Transmit
- Scan Operation
- Talkback Scan
- Scan All Groups
- Change the Scan List
- Scanning Options
- Scan Delay
- Talk Around
- Scan in Tone Mode
- Scan in Monitor Mode
- Transmit on Priority Channel
- Channel Scan Delete/Add
- Priority Scan
- Priority Scan with Code Guard
- Priority Modes
- Priority Delay
- Priority Receiving
- Priority During Scan-All-Groups Scanning
- Receive Mode
- Groups
- Display Modes
- Tuning Range
- Frequency Display Mode
- Alpha Display Mode
- Channel Display Mode
- Selective Calling
- Receiving a Call
- Sending a Call
- Radio Check
- DTMF Dialing
- Originating a Call
- Frequently Called Numbers and Call Paging
- Radio Paging
- Flex Mode
- Keypad and Channel Selector Lock
- Busy Channel Lockout
- Battery Power
- Battery Saver
- Radio Power-Up
- Error Messages
- Stun
- Aurora Programmed Switch Settings
- Troubleshooting Guide
- Service
- _
- Specifications
- Definitions and Acronyms
47
Aurora User’s Manual
Channel Scan Delete/Add
With the Aurora radio, you can delete and
add channels to the scan list in each group if
this feature is programmed in your radio.
To add or delete a channel from the scan list:
1. Use the function menu to put the radio in
scan mode on an active receive carrier.
2. Tune your radio to the frequency of a
receive channel frequency, or open the
squelch to the channel being added or
deleted.
3. Press [E]nter to toggle between deleting
or adding a channel to the scan list.
If the channel is already in the scan list,
pressing [E]nter will delete it from the scan
list, and if the channel is not on the scan list,
pressing [E]nter will add the channel to the
scan list.
When the radio is on a channel in manual
mode (or scan mode on an active channel)
and you have deleted the channel from the
scan list, the display will indicate that this
channel is not on the scan list by displaying
“d” in the first alpha character position of the
display. If the channel is the group’s priority
channel, then a “p” is shown instead of “d”
for a deleted channel.
Squelch Knob
Channel
deleted from
scan list
Priority channel
deleted from
scan list
d
000.0000
P
000.0000