Instruction Manual

05
HOW TO ENABLE AND DISABLE THE NEEDLE
POSITIONING FUNCTION
• Press the “P” button 2 times and the LED will change to "n1"
• Press the “S” button to select between “0” and “1”
• Select “0” to disable the needle positioning function
• Select “1” to enable the needle positioning function
• Press the “P” button to save the selection
HOW TO SET THE STOP POSITION OF THE NEEDLE:
This programming should only be used when the OPTIONAL synchronizer is
installed. Order separately.
• Press the “P” button 3 times and the LED will change to "n2"
• Press the “S” button to select between “0” and “1”
• Select “0” and the needle will stop in the down position
• Select “1” and the needle will stop in the up position
• Press the “P” button to save the selection
SETTING THE “F” MODE N5 TO N6
STEP 1:
• First, press and hold the “S” button. Then press and hold the “P” button. Keep
both buttons pressed until “F” appears on the display.
• When “F” appears, release both buttons and then press the “P” button to
advance to parameter “5”.
• When “5” appears, keep pressing only the “S” button to advance to “0” (low
speed start disabled).
• Press the “P” button to save the value.
STEP 2:
• First, press and hold the “S” button. Then press and hold the “P” button and
keep both buttons pressed until “F” appears on the display.
• When “F” appears, release both buttons and then press the “P” button to
advance to parameter “6”.
• When “6” appears, keep pressing the “S” button only to advance to “9” (step
sewing higher value).
• Press the “P” button to save the value.
• Switch the power off and then switch the power back on to complete the
programming.
* Please note: When sewing dense materials (ex. Tooling leather), a size 22 leather
point needle is recommended.