Instruction Manual

03
IMPORTANT SAFETY INSTRUCTIONS
READ ALL INSTRUCTIONS BEFORE USE
When using your UberLight, basic safety precautions should always be followed.
Please read the following instructions carefully as they provide important informa-
tion concerning how to install, use and care for this product.
• Make all connections before plugging the light into the power source.
• Ensure there are no exposed wires after connections are done.
INSTALLATION INSTRUCTIONS FOR 1000TL
CONNECTING THE 1000TL TO AN EXISTING 110V PUSH BUTTON SWITCH
1. Turn the power source off or unplug the machine.
2. Remove the switch box cover.
3. Cut an opening 9/32" (7MM) x 3/16" (6MM) on the upper right hand side of the
switch box cover approximately 15/32" (12MM) from the top edge this will allow
for the passing of the wire without pinching when the cover is re-attached.
4. Connect the green lead from the 1000TL together with the green lead already
in the box and securely tighten the screw.
5. Connect the black lead from the 1000TL together with the black or brown lead
on the terminal block and securely tighten the screw.
6. Connect the white lead from the 1000TL together with the white or blue lead
on the terminal block and securely tighten the screw.
7. Use insulated staples to fasten the power cord.
CONNECTING THE 1000TL TO 220V SINGLE PHASE
1. Turn the power source off or unplug the machine.
2. Loosen (2) screws on the power cord strain relief and push the 1000TL lead
through the strain relief allowing approximately 5” of wire into the utility box
to make the connection.
3. Connect the green lead from the 1000TL together with the green lead already
in the utility box and securely tighten the screw.
4. Connect the black lead from the 1000TL together with the black lead on the
terminal block and securely tighten the screw.
5. Connect the white lead from the 1000TL together with the white lead on the
terminal block and securely tighten the screw.
6. Use insulated staples to fasten the power cord.