User's Manual

RDL-3000 User Manual
70-00158-01-DRAFT Proprietary Redline Communications © 2011 Page 113 of 150 November 25, 2010
Table 30: CLI - set
vid - VLAN ID
grpviden <id> <off | on>
Display the status or enable/disable this Service Group.
id - [id number]
off - Disabled
on -Enabled
http <off | on>
Enable or disable the HTTP function. When disabled, the Web interface will not be
available.
off - Disable
on - Enable
https <off | on>
Enable or disable the HTTPS function.
off - Disable
on - Enable
idname <id> <name>
View or modify the name associated with an ID.
id - ID for Link, Service, or Service Group.
name - Name (maximum 15 text characters).
ipaddr <ip> <mask>
Enter the IP address and subnet mask of the RDL-3000. Confirmation is required.
Example:
set ipaddr ip 192.168.100.10 mask 255.255.255.0
ldlpir <id> <50-50000>
Link downlink PIR.
id = Link ID number.
lulpir <id> <50-50000>
Link uplink PIR.
id = Link ID number.
maxdst <distance>
Maximum distance to a subscriber.
value - Distance (Km) to farthest subscriber.
maxtxpower <-10 - 25>
Enter the Tx power level (dBm). This setting is for the transceiver output only. The
actual EIRP depends on the gain of the connected antenna. The maximum
value is determined by the options key.
mgmtag <off | on>
Enable or disable the HTTPS function. See also mgmvid.
off - Do not use VLAN to identify management traffic.
on - Enable VLAN tagged management traffic. See mgmvid.
mgmvid <1 - 4095>
Specify Management VLAN ID. See also mgmtag.
vlan_id - Management VLAN ID.