User's Manual

RDL-3000 User Manual
70-00158-01-DRAFT Proprietary Redline Communications © 2011 Page 111 of 150 November 25, 2010
Table 30: CLI - set
id - Service ID number.
gid - Service Group ID number.
conlid <id> <lid>
Assign a Link to this Service.
id - Service ID number.
lid - Link ID number.
conpri <id> <0 - 7>
Service default priority.
convid <id> <1 - 4095>
Set or show Service VLAN ID
id - Service reference ID number.
conviden <id> <off | on>
Enable or disable VLAN connections.
id - Service ID number.
on - VLAN is enabled.
off - VLAN is disabled.
dfsaction <none | txoff | chgfreq>
Select the mode of operation for DFS.
None (0): The DFS function is disabled.
Tx Off (1): Transmission is immediately disabled when radar signals are
detected. This action is recorded in the message log and an SNMP trap
message is sent (if SNMP enabled).
Chg Freq (2): Relocate transmission to an alternative frequency immediately
when radar signals are detected. This action is recorded in the message log
and a trap message is sent (if SNMP enabled).
dlminrate <id> <1 - 54>
Link minimum downlink uncoded burst rate (Mbps). Entry values are dependent on the
channel bandwidth (chsize).
id = Link ID number.
dlcir <id> <50 - 50000>
Service downlink committed information rate (CIR) (Kbps).
id - Service ID number.
dlpir <id> <50 - 50000>
Service downlink peak information rate (PIR) (Kbps).
id - Service ID number.
dlrate <id> <6 - 54>
Link maximum downlink uncoded burst rate.
id = Link ID number.
dlratio <20-80>
Set the downlink ratio.
encmode <0 - 4>
Set the encryption mode. The same encryption level must be selected on
communicating systems.
0 - Disable