Installation Guide

RDQCI5022 Rev.0
Page 10 Cered 06/01/2016
Tile Ready® Brand Shower Pan Installaon Addendum
SPECIAL INSTRUCTIONS FOR REDI DOOR® ENCLOSURE INSTALLATIONS WITH TILE READY® BRAND SHOWER
PANS
Designated screw pack for Tile Ready® Brand Shower Pans:
For Redi Door® enclosure installaons with a Tile Ready® brand shower pan, a special screw pack containing
eight (8) #8x¾” pan-head screws is included with your door. These #8x¾”screws replace curb screws included
in the main hardware package, and their use is mandatory. Set drill stop at 5/8” to avoid piercing the shower
pan curb.
FAILURE TO USE THE CORRECT SCREWS & FOLLOW THESE INSTRUCTIONS WILL VOID THE TILE READY® BRAND
SHOWER PAN LIMITED WARRANTY.
1. Align the u-channel in the proper posion on the curb/entrance
2. Mark and drill a 3/16” hole through the u-channel
3. Transfer this locaon to the le and drill a 3/16” hole through the le and grout only 4. Insert a dab of
silicone caulking into the hole
5. Put the u-channel in place.
6. Using the provided #8 x ¾” pan-head screw, fasten the u-channel in place on the curb.
Special instrucons for Tile Ready® Brand Barrier Free entrances:
For Redi Door® enclosure installaons on a Tile Ready® brand BARRIER FREE entrance, only silicone seal should
be used to aach enclosure parts to the shower pan entrance. No screws or nails should be used to install
enclosure hardware into the shower pan entrance.
THE USE OF SCREWS OR NAILS IN THE BARRIER FREE ENTRANCE WILL VOID THE TILE READY® BRAND SHOWER
PAN LIMITED WARRANTY.