Installations Instructions

1
Prepare cabinet
1. Carefully remove all packing material. Place hardware package aside until
the contents are needed.
Determine location
1. The commonly accepted height of bath cabinets is 64” from the finished
floor to the center of the mirror area. However, height may be adjusted to
individual preference.
2. For maximum security, mount cabinet directly to wall studs.
Mount cabinet
NOTE: For ease of installation, the assistance of one or two
additional persons is recommended.
1. Measure and mark four (4) mounting holes on the wall corresponding to the
pre-drilled hole locations in the mounting bars on the inside back panel of the
cabinet. (FIG 1) Draw horizontal lines connecting the two
top and two bottom marked locations. The lines should be level. Adjust to
level if necessary. Repeat this process with vertical lines connecting the two
left and two right marked hole locations. After insuring the marks are level,
verify the mounting holes in the cabinet back match the marked wall
locations.
2. Drill 9/64“ diameter holes at the marked locations on the wall. If
mounting holes are not located at a stud, the hole diameter, in the
wall, must be increased to accommodate wall anchors. Position
wall anchors as required.
3. Hold cabinet in place and make sure it is level.
4. Attach the cabinet to the wall with the four mounting screws from
the hardware pack.
NOTE: Do not use nails to mount the cabinet.
NOTE:
Irregularities in wall surface may cause distortion of cabinet
body when mounted. Place shims between cabinet and wall
as necessary.
INSTRUCTIONS FOR WALL-MOUNT INSTALLATIONS
SIZE FINISH
24” x 24” White
30” x 26” White
36” x 30” White
48” x 30” White
24” x 24” Oak
30” x 26” Oak
36” x 30” Oak
48” x 30” Oak
CABINET
FIG 1
Cabinet Back
Inside View
(without doors)
BOTTOM
MOUNTING
HOLES
CAUTION: Do not over tighten the set screws. Screws
turned down too tight will break the mirror.
FIG 2
TOP
MOUNTING
HOLES
Door Adjustment
1. Check for clearance and alignment between mirror doors. It may be necessary
to adjust individual doors. Loosen the set screws on the inside of the door
hinges about a 1/4” turn for door(s) needing to be adjusted. (FIG 2)
2. Realign so the doors are “square” and swing without interference.
3. Lightly retighten the set screws.
DESCRIPTION
SERVICE PARTS
* Standard Hardware – may be purchased locally.
ONE YEAR LIMITED WARRANTY
Date of Installation __________________________________________________________________________________________________________________________________________
Model No and Product Description _____________________________________________________________________________________________________________________________
Hinge Set ( 1 ea Top & Bottom)
Magnetic Latch
Mounting Screw 8 X 1-3/4” PPH Type A
Wall Anchors
We warrant to the original consumer purchaser of its products that such products will be free from defects in materials or workmanship for a period of one (1) year from the date of original
purchase. THERE ARE NO OTHER WARRANTIES, EXPRESS OR IMPLIED, INCLUDING, BUT NOT LIMITED TO, IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A
PARTICULAR PURPOSE.