User Manual

Adjusting the Handlebar Height
(Select models Only)
Collar Clamp
Tool Required: 5 mm Allen Wrench
ASSEMBLY AND SET-UP
Need Help? Visit our website for replacement parts, product support, a list of authorized service centers in the US and customer service contact information
at www.razor.com. Please have the product I.D. code (located on the white label of your product) available for better assistance. Additional Customer
Service contact information is listed at the back of this manual.
4
Note: The tension of the quick-
release lever can be adjusted by
manually tightening or loosening the
Allen bolt. Be careful not to over-
tighten. You should always be able
to open and close the quick-release
lever by hand and the T-bar should
slide freely when the quick-release
is open.
1 To adjust the height of the
handlebars, open the quick-release
lever and slide the T-bar to the
desired position and resecure the
quick-release lever to lock into
place. When the T-bar is raised to
the maximum height, depress the
push button located directly below
the quick-release lever to unlock
the T-bar.
WARNING: Failure to
properly secure the quick-release
lever may cause the T-bar to
telescope up or down while riding
and may cause you to lose control
and fall.
Using a 5 mm Allen wrench, check that the collar clamp bolt(s) are tightened
securely. This item is tightened and quality inspected at the factory, but
there is a slight chance that the effects of shipping or handling may have
caused the bolt(s) to loosen.
WARNING:
Failure to properly install and/
or tighten the collar clamp may
cause the rider to lose control and
fall. If you are having difficulty
understanding these instructions,
please contact Razor Customer
Service for assistance.