User Manual

LED Remote Controller
Model: BR01-11 / BR01-20 / BR01-30 / BR01-40
Operation
1. Pair the remote to receiver
The remote controller needs to be paired to receiver to work. User can pair up to 5
remote controllers to one receiver and each single remote controller can be paired to
any receiver.
To pair a new remote to the receiver, please operate with following two steps:
1). Cut off the power of receiver and power on again after more than 5 seconds.
2). Hold press the two keys noted with pair function simultaneously and briefly
within 10 seconds after receiver powered on.
After this operation, the remote is paired to the receiver and ready to work.
Specification
Working voltage
Wireless protocol
Frequency band
Wireless power
Working temperature
DC 3V, CR2032 battery
Umi protocol based on SIG BLE Mesh
2.4GHz ISM band
< 7dBm
-20-55 C(-4-131 F)
2. Unpair the remote controller
To unpair the remote from the receiver, please operate with following two steps:
1). Cut off the power of receiver and power on again after more than 5 seconds.
2). Hold press the two keys noted with unpair function simultaneously within 10
seconds after receiver powered on.
After this operation, the remote will be unpaired from receiver.
Umi Smart Wireless
80%100% 60%
20%40% 10%
WARM
NEUTRAL
COLD
MODE
+
DEMO
SPEED
-
SPEED
+
COLOR
-
COLOR
+
MODE
-
-
SPEED
COLOR
+
COLOR
-
+
COLOR
SPEED
+
-
EFFECT EFFECT
Pair
Unpair
Pair
Unpair
Pair
Unpair
Pair
Unpair
BR01-11 BR01-20
BR01-30 BR01-40
3. Model matching
Each model remote controller is designed to work with matched receivers only. The
remote will work improperly if been paired to mismatched receivers.
Each model needs to be matched with different function receivers as below:
BR01-11 --------- Single color.
BR01-20 --------- Tunable white (CCT).
BR01-30 --------- RGB color.
BR01-40 --------- RGB+White or RGB+CCT.