Owner's Manual

23
Important: When diagnosing or troubleshooting your system, always begin by reviewing
the Wired Network Settings and Wireless Network Settings below.
Settings
Device Information
Firmware Version: This is current firmware
version running on your Zonetech.
Serial Number: This is the serial number of
your Zonetech unit.
Wired Network Settings
DHCP IP and Subnet Mask: This is the
dynamic IP address and subnet mask
assigned through DHCP (Dynamic Host
Configuration Protocol), if supported by
your network.
Static IP and Subnet Mask: Enter a
manually assigned IP address and subnet
mask for the connected wired network.
MAC Address: This displays the unique
MAC (Media Access Control) address of
your Zonetech device.
Wireless Network Settings
Enable: This enables or disables wireless
network connection.
SSID: This is the name of the connected
wireless network.
Password: This is the password of the
connected wireless network.
Connection Status: This is the status of
the current wireless network connection.
Available SSIDs: These are the available
wireless networks within range of your
Zonetech.
DHCP IP and Subnet Mask: This is the
dynamic IP address and subnet mask
assigned through DHCP, if supported by
your network.
Static IP and Subnet Mask: Enter a
manually assigned IP address and subnet
mask for the connected wireless network.
MAC Address: This displays the unique
MAC address of your Zonetech device.
Security Levels
Full Access Password: This is the
password used for entering Full access
mode in the web interface.
Limited Access Password: This is the
password used for entering Limited
access mode in the web interface.
Note: When a password is empty, users
will be logged in automatically at that
level.
Front Panel Security: This sets the
access level for the front panel controls:
Full, View Only, or Limited.
Note: In View Only mode, no changes to
any settings are permitted.