Owner's manual

Manual-3
Rear Panel Description
INPUTS
+– +– +– +–
43 21
OUTPUTS
+– +– +– +–
87 65
+– +– +– +–
43 21
+– +– +– +–
+– +– +– +–+– +– +– +–+– +– +– +–+– +– +– +–
87 65
AES3 OUT AES3 IN
+12
VERSATILE OUTPUT PORT
OPEN COLLECTOR
12345 76 8
+40 VDC / 100 mA MAX
100 mA
MAX
GND
+12
12345 76 8 GND
+5v /
100 mA
0-5V
REF 12345 76 8 GND
REF
12345 76 8 GND
VERSATILE INPUT PORT
100-240V
55 WATTS50/60 Hz
FOR CONTINUED
GROUNDING
PROTECTION
DO NOT REMOVE
SCREW
RPM 88
ACN 001 345 482
MADE IN U.S.A.
RANE CORP.
DEFAULT LAN
10Base-T
LINK
REMOTE INTERFACE PORT
A B +V -V
A B +V -V
(RW 485)
This device complies with Part 15
of the FCC Rules. Operation is
subject to the following two
conditions: (1) this device may not
cause harmful interference, and
(2) this device must accept any
interference received, including
interference that may cause
undesired operation.
COMMERCIAL AUDIO
EQUIPMENT 24TJ
R
1 10 9 8 7 6
23
45
1 POWER IEC jack connects to AC line voltage, 100-240 VAC ±10%.
2 Balanced analog audio Inputs 1 through 8. Euroblock connectors.
3 Balanced analog audio Outputs 1 through 8. Euroblock connectors.
4 AES3 digital audio Input and Output. XLR female (input) and male (output) connectors.
5 Versatile Input Port provides 8 logic or voltage inputs for remote level control and Preset recall. Euroblock connector.
6 Versatile Output Port provides 8 logic outputs capable of driving small relays, LEDs or other logic inputs. Euroblock connector.
7 RW 485 Port communicates with Rane’s Smart Remotes. A maximum of 280 mA of current is available for powering remotes.
Euroblock connector.
8 LAN and LINK reect the state of the Ethernet connection. LINK lights solidly when a valid connection to another Ethernet
device (e.g., a PC) is detected. LAN ashes when communicating with another Ethernet device.
9 10Base-T jack accepts a standard Ethernet cable. RJ-45 connector.
0 DEFAULT button recalls Preset 1 when pressed. Holding this button while applying power puts the unit into a special codeload
mode for updating rmware. e letters “CL” appear on the PRESET LED display when the device is in codeload mode.