DANGER READ AND OBEY ALL SAFETY AND OPERATING INSTRUCTIONS BEFORE OPERATING TOOL.
TABLE OF CONTENTS / INTRODUCTION Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Safety Precautions. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
SAFETY PRECAUTIONS WARNING: When using pneumatic tools, basic precautions should always be followed to reduce the risk of personal injury. WEAR EYE AND HEARING PROTECTION. Always wear hearing and eye protection devices when you are operating the GypFast Air, Air HD tool or working in the vicinity of this tool. Also, your eye protection must meet the requirement of ANSI Standard Z87, and should have side shields for increased protection.
SPECIFICATIONS / AIR SYSTEMS SPECIFICATIONS Tool Type: Dimensions (H x L x W): Weight w/out Nails (GYPFASTAIR): Weight w/out Nails (GYPFASTAIRHD): Activation Mode: Energy Source: Maximum Permissible Pressure: Recommended Operation Range: Magazine Capacity: Air Consumption (GYPFASTAIR): Air Consumption (GYPFASTAIRHD) Coil Nailer 12” (303mm) x 13” (329mm) x 5.5” (137mm) 5.8 lbs (2.6 kg) 6.2 lbs (2.8 kg) Contact / Sequential Compressed Air 120 PSI (8.27 bar) 71 to 113 PSI (4.9 to 7.8 bar) 150 nails 2.
TOOL LOADING / TOOL OPERATION TOOL LOADING TOOL OPERATION LOADING AND UNLOADING NAILS OPERATION OF TOOL This tool is equipped with a safety yoke, which must be pushed to the work surface for the tool to operate when the trigger is actuated. Two methods of tool actuation are: 1. Lay the tool on its right side, exposing the gate latch. 2. Unlatch and open the gate. Swing open the magazine cover. 3. Uncoil 3” of nails. 4.
MAINTENANCE COLD WEATHER OPERATING PRECAUTIONS Keep the tool in a warm area until you are ready to use it. If the tool is already cold, bring it into a warm area, and allow it to warm up before using it. If you must use the tool in cold conditions, drive several fasteners into a scrap piece of wood at the lowest air pressure at which the tool will operate. Gradually increase the air pressure while continuing to drive fasteners until the desired operating pressure is reached.
WARRANTY RAMSET AIR TOOL SYSTEMS WARRANTY AND LIMITATIONS Ramset warrants that new GypFast Air and Air HD systems power fastening tools, parts and accessories will be free from defects in material and workmanship for the period shown below. TWO-YEAR WARRANTY A two-year warranty will apply to all parts, except those listed below as normal wearing parts, or parts which are specifically covered by an extended warranty.
FOR TOOL REPAIR SERVICE CONTACT YOUR LOCAL AUTHORIZED RAMSET DISTRIBUTOR OR TO FIND YOUR NEAREST RAMSET TOOL REPAIR CENTER VISIT OUR WEB SITE AT WWW.RAMSET.COM OR CALL 800-241-5640 Concrete Fastening Systems Glendale Heights, IL 60139 800-RAMSET6 (1-800-726-7386) www.ramset.com Buy with Confidence... Buy From Your Authorized Distributor AN ILLINOIS TOOL WORKS COMPANY © ILLINOIS TOOL WORKS 2009 PRINTED IN THE U.S.A. Form No.