Specification

ITW Brands
2/18/11
Ramset PAT Sell Sheet
ITW00311
00000 Ramset PAT Sell Sheet Front-r2.ai
Adobe Illustrator CS4
CMYK PMS 172
The Ramset System is designed for quick, easy and permanent fastening to concrete and steel.
A powder load fires a hardened steel pin through the item you want to attach and into the substrate.
All users must read the tool manual thoroughly and complete a licensing test before using.
Licensing test is available in tool manual or online at www.ramset.com
Choose the right pin:
All Ramset Pins are the
same diameter, but they
are available in a variety
of different lengths, with
and without washers.
To use the Cobra+ Tool:
To use Ramset
Single Shot Tools:
Choose the right load:
All Ramset tools stocked
at The Home Depot
(except Cobra+) use .22
caliber single shot loads.
Insert a pin into the tip of
the barrel. The orange
flutes center the pin and
hold it in place.
Insert a single load into the
chamber with the rounded
tip facing forward. Pull the
barrel back to close the tool.
Press the tool firmly against
the item you want to fasten,
compressing the barrel. Pull
the trigger to fire the tool.
NOTE:
To fire the Hammer-Shot
Tool, strike the firing pin
button with a 1 lb. hammer.
The Cobra+ Tool uses the same pins as the other Ramset Tools, but it is designed
to use .27 cal. 10 shot strip loads. This makes the tool more powerful and faster
to use for multiple fastenings.
The Cobra+ Tool also features an
adjustable power level for optimal
penetration into the base material.
Choose a pin that is long enough to penetrate at least 1" into concrete and at least 3/16" through steel.
Loads are available in three color-coded power levels which determine how much force will drive the pin.
Harder substrates require higher power levels, but pins should not be overdriven.
POWDER FASTENING SYSTEMS
Wood to Concrete Wood to Steel Steel to SteelSteel to Concrete
M
o
r
t
a
r
J
o
i
n
t
C
o
n
c
r
e
t
e
B
l
o
c
k
S
o
l
i
d
C
o
n
c
r
e
t
e
31 2
1 2 3 4