Installation Instructions RainTight Decks www.raintightdecks.
Underdeck Installation Instructions Table of Contents Page 3 Tools Required Page 4 Introduction and How the system works Page 5 Step 1: Establishing the Height and Slope Step 2:Installing the framing Step 3: Proper Caulking and Flashing Page 6 Step 4: Gutter Install Step 5: Preparing for the Panels Step 6: Panel Install Step 7: Trim out the Perimeter Page 7 Step 8: Install Downspouts Step 9: Finish and Enjoy Accessories 2
Underdeck Systems Instructions Guide Basic Tools Needed Hammer Tape Measure Caulk Line Metal Snips Hand Brake Caulking Gun Cordless Drill 4β or 6β Level Safety Glasses Electric Circular Saw While we have tried to address each tool needed, however common sense rules will apply. Do NOT attempt to use the wrong tool for the job and avoid the serious injury. If you have any questions, please contact us. We are standing by to assist you everyway we can.
Underdeck Systems Installation Guide Introduction Underdecking systems are a new and innovative product for the home improvement industry. It involves the installation of seamless and watertight panels under your existing deck that help collect the water that fall through the decks slats. Our Rain Tight Deck systems will not only open up these opportunities for you, but it will also add extra living space and resale value to your home. Each deck is unique - And so is yours.
Underdeck Systems Instructions Guide Slope from house to gutter STEP 1: ESTABISH THE HEIGHT AND SLOPE OF THE CEILING Start by determining the drainage and slope. It is normally best to drain away from the house, however, you can drain towards the house and tie into existing drain pipes. Once this step is completed, you will know the direction of the fall and where the downspout will be located when the panels are fully installed. 1.
Underdeck Systems Installation Guide STEP 3: PROPER CAULK AND FLASHING SYSTEM 1. Successful installation of your deck is dependent on proper sealing and flashing at the surfaces where the deck meets your home or other structure. Water must be properly diverted to avoid leakage. 2. The trim flashing included will be bent to divert water into the panels around the entire inside perimeter of your deck. You must remain above the 2x2 framing already in place to allow the water to be diverted to the panels. 3.
Underdeck Systems Installation Guide STEP 6: PANEL INSTALLATION 1. Begin to install, or hang your under deck panels. You will be interlocking these panels into place against the previous panel. 2. Each panel is screwed using 1 ΒΌβ galvanized screws into the carriage system, making sure that the end of the panel is properly positioned in the gutter. You can make the needed adjustments with your screws to insure the panel rests on the gutter. 3.
Underdeck Systems Installation Guide 8
Underdeck Systems Installation Guide Accessories To further customize your new living space, you can install fans or LED lighting. Contact your local electrician for assistance. Thank you for choosing RainTight Underdecking for your underdeck project.
Underdeck Systems Installation Guide Additional Installation Images These are sequential images that should assist you in the installation process 10