User Manual

www.petsafe.net 5
Set Up the Transmitter
Important: You may need to move the Transmitter several times before determining the final location.
The Transmitter is located at the exact center of the Pet Area. Place the Transmitter:
• 2 to 4 feet above the floor.
• In a dry, well ventilated, protected area.
• In an area where temperatures do not fall below freezing (e.g., garage, basement, shed, closet).
• On a non-metal table or mount on a wall (1A). A mounting template is included on the back of this guide.
• At least 3 feet from large metal objects, as these items may reduce the size and shape of your Pet Area (1B).
To maximize your Pet Area, make
sure the Boundary Switch is on
“High” and the Boundary Control
Dial is set to “8” (1C). Plug Power
Adapter into Power Jack and standard
120-volt outlet. Turn the Transmitter
on.
Prepare the Receiver Collar
Your Receiver Collar comes with short Contact Points installed. Use the long Contact Points for pets with long
or thick hair. Tighten the Contact Points with pliers one-half turn beyond finger tight (2A). Check the tightness
weekly.
To Insert and Remove the Battery
Note: Do not install the battery while the Receiver Collar is on your pet.
This Receiver Collar utilizes a replaceable PetSafe
®
battery (RFA-67). This unique battery is designed to make battery
replacement easier and increase water protection.
To insert the battery, align the symbols on the battery (arrow) and Receiver Collar (triangle) (2B). Use a large coin
to turn the battery clockwise until the arrow lines up with the lock symbol on the housing (2C) .
To remove the battery, turn the battery counter-clockwise using a large coin (2D, 2E). DO NOT attempt to cut
into or pry open the battery. Be sure to discard the used battery properly.
A replacement PetSafe
®
battery (RFA-67) can be found at many retailers. Contact the Customer Care Center at
1-800-732-2677 or visit our web site at www.petsafe.net to locate a retailer near you.
W
WW
PA
TIEN
3
3
2
A-67
4
1
2
5
Step
2
Operating Guide
Step
1
BOUNDARY
CONTROL
7
8
Power
Boundary Switch
Low
High
8
1m
(3ft)
Wal l
Mount
Tabletop