User's Manual

10 SPORTDOG.COM
GETTING STARTED
STEP :: 01
PREPARE THE GPS COLLAR/ECOLLAR MODULE
YOU MUST COMPLETE THESE STEPS PRIOR TO USING THIS DEVICE FOR THE FIRST TIME.
TO CHARGE THE GPS COLLAR/ECOLLAR MODULE:
1. Attach the supplied Charge Cradle so that the SportDOG Brand
®
logo on the Charge Cradle covers the SportDOG Brand logo on the
GPS Collar.
2. Connect the appropriate charger connector to the charging jack.
3. Plug the charger into a standard 120/240-volt AC wall outlet.
4. Charge the GPS Collar for 4 hours for the first charge and every
charge thereafter. It is not harmful to let the unit charge more than
4 hours.
5. When charging is complete, as indicated by the Indicator Light
blinking green, remove the Charge Cradle.
NOTE: Approximate battery life between charges is 24 hours (at the 3
second update rate) depending on the frequency of use
.
TO TURN THE GPS COLLAR/ECOLLAR MODULE ON:
Press the On/Off button and release when the GPS Indicator Light comes on green. The GPS Collar will beep 1to 5
times indicating which channel the collar is on.
TO TURN THE GPS COLLAR/ECOLLAR MODULE OFF:
Press and hold the On/Off button until the GPS Indicator Light comes on solid red and the GPS Collar beeps for 2
seconds. To extend the battery life between charging cycles, turn off the GPS Collar when it is not in use.
TEST LIGHT INSTRUCTIONS
1. Turn the Collar Receiver on.
2. Hold the Test Light Contacts to the Contact Points.
3. Press a Static Stimulation Button on the Remote Transmitter.
4. The Test Light will flash.
NOTE: At higher static stimulation levels, the Test Light will flash brighter.
5. Turn the Collar Receiver off.
Save the Test Light for future testing.
NOTE: If the Test Light does not flash, recharge the battery and re-test. If the Test Light still does not flash, contact the
Customer Care Center at 1-800-732-0144