Owner`s manual
22
• If you make an error, the TAD
beeps rapidly 5 times. Repeat
Steps 2–5.
6. Press
FLASH/REMOTE
so the
TALK/BATT LOW indicator turns
off.
SELECTING AN
OUTGOING MESSAGE
The TAD has two prerecorded mes-
sages. One asks the caller to leave a
message (“Hello, no one is available
to take your call. Please leave your
message after the tone.”); the other is
simply an announcement and does
not let the caller leave a message
(“Hello, no one is available to take
your call.”). You can also record your
own message (see “Recording an
Outgoing Message”).
Use the
REC TIME
switch to select
which message you want. When you
set it to either
1
or
4
(minutes), the nor-
mal message is selected and the TAD
records each incoming message for 1
or 4 minutes. When you set it to
ANN
,
the announce-only message is select-
ed.
Recording an Outgoing
Message
You can record your own message up
to 1 minute long for the caller to hear
when the TAD answers a call. Use the
handset to record the message.
If you record an outgoing message,
the TAD plays it instead of either of
the prerecorded messages. Depend-
ing on the
REC TIME
switch setting, ei-
ther tell callers to leave a message or
state your message as an announce-
ment.
Hint:
Do not tell callers that you are
not home. Instead, say that you can-
not come to the phone right now.
Follow these steps to record your out-
going message.
1. Press
FLASH/REMOTE
on the
handset so the TALK/BATT LOW
indicator lights green.
2. Hold down
OGM REC/8
for about 2
seconds until the handset beeps.
Then speak your outgoing mes-
sage into the handset.
3. The TAD automatically stops
recording after 1 minute, or you
can press
STOP/7
when you finish
the message. The handset beeps,
plays back the message, then
beeps again.
43-776.fm Page 22 Friday, August 13, 1999 3:34 PM