- RadioShack Scanner User Manual

Beyond the Basics

6. When the scanner has successfully received all data, End

appears. If the scanner received an error while receiving

data, End, d-Err, and its frame number appear. If the

scanner received a communication error while receiving

data, C-Err indicates the packet number where the error

occurred. If the scanner received a checksum error while

receiving data, S-Err indicates the packet number where

the error occurred. If the scanner received a length ﬁ eld

error while receiving data, L-Err indicates the packet

number where the error occurred.

cloning your scanner

You can clone all the frequencies, trunking talk groups, and

ﬂ eet maps programmed in your PRO-2051 to another

PRO-2051 using an optional interface cable and software

(available at your local RadioShack or www.radioshack.com).

1. Make sure the scanners are turned off and then plug the

cable into each scanner’s PC/IF jack.

2. While you press and hold E on both scanners, turn on

both scanners.

3. Determine the scanner which has the frequency data that

you want to transfer. This one must be set up as the “First

Unit”, and the other must be set as the “Clone Unit”.

4. On the scanner that is the “Clone Unit”, press

e or d to

select CLONE, then press HOLD/RESUME.

5. On the scanner that is the “First Unit”, press

e or d to

select FirSt, then press HOLD/RESUME. The data transfer

begins from the First Unit to the Clone Unit.

During data transfer, SNDFirSt appears when a scanner is

sending data and REC CLONE appears when a scanner is

receiving data. When the data transfer is complete, donE

appears. If the data transfer is not successful, Error appears.