Installation Guide

ManualsBrandsRack It Up! ManualsKitchenLong Bookshelf Wall Rack Utensil Bar w 12 Hooks Steel Gray Hammertone

IMPORTANT!

We are committed to the highest quality in the manufacture of this RACK IT UP! pot rack. The components of

each rack are carefully inspected before shipment.

However, in case there is a problem, PLEASE LET US HELP YOU FIRST. Do not return the item to where you

purchased it. First, call us and explain what is missing or wrong. We will do our best to help with any question or

problem you have—and as fast as possible.

Call us TOLL FREE 1 (877) 362-5863 and ask for customer service. Thank you!

TOOLS NEEDED - We provide all tools required for assembly: hex wrench, fastener hardware (nuts, bolts).

Note under attaching instructions on page 3 of this booklet, the list of tools you will need to provide.

RACK IT UP! 1-Year Limited Warranty

This product is warranted to be free of material defects for a period of one year from the date of purchase. Your exclusive

remedy is the repair or replacement of the defective product, and shall be subject to the following conditions: (1) You send a

notice of any defect to RACK IT UP! within the warranty period, and (2) You return the defective product, to RACK IT UP!,

24 Colwell Street, Port Hadlock, WA 98339, postage prepaid, within 20 days following receiving a return authorization num-

ber. (A return authorization number may be obtained from RACK IT UP! by calling the number at the bottom of this book-

let.) There are no other warranties expressed or implied. There are no warranties of merchantability or fitness for a particu-

lar purpose. RACK IT UP! specifically disclaims any and all incidental or consequential damages arising out of purchase,

installation or use of this product.

Lge Bkf P R

M MPL 16

Summary of content (4 pages)

PAGE 1
Large Bookshelf Pot Rack Model MPL 16 IMPORTANT! We are committed to the highest quality in the manufacture of this RACK IT UP! pot rack. The components of each rack are carefully inspected before shipment. However, in case there is a problem, PLEASE LET US HELP YOU FIRST. Do not return the item to where you purchased it. First, call us and explain what is missing or wrong. We will do our best to help with any question or problem you have—and as fast as possible.
PAGE 2
How To Assemble Your Pot Rack TIP! FIRST, REMOVE PAINT FROM BOLT HOLES. Because the powder coat finish applied at the factory also adheres to the inside of bolt holes, pushing a bolt through it during assembly may be difficult. Therefore, before connecting parts, we recommend that you check to see that bolts slip easily through all holes. If they do not, carefully clear paint from holes in side bars, ends and arms using a small knife.
PAGE 3
STEP 3: ATTACH FIRST ARM CONTINUED Now remove the barrel bolt (28A) from one of the corners, keeping barrel nut (28B) in position. Place a curve arm (22) (2-hole end) on the OUTSIDE of the body. Align the three pieces: (side bar 3A) on inside, bookshelf end piece (9A) in middle, arm (22) on outside), and reinsert the barrel bolt (28A) through the upper hole from the OUTSIDE. Repeat for lower hole. Do not tighten barrel bolts firmly until all bolts are in place.
PAGE 4
Installation of Drywall Anchors Bookshelf Rack TOGGLER® brand SNAPTOGGLE® Toggle Bolt Installation Instructions. DO NOT attempt to test the toggle as you will be unable to use them again. Need additional toggles? You may purchase them at Lowes or find a local store on toggler.com. IMPORTANT! If your house is older (maybe a Victorian?) with lath board plaster ceilings and walls, DO NOT use the new drywall anchor system. Old lath board plaster walls are not strong enough to hold drywall anchors.