Owner`s manual

6
No. L-A2-17509
REV 7 - 0903130830
CONNECTING THE GAS SUPPLY
1. The burner pan is supplied with a fuel injector
for natural gas. The fuel injector must be used
in ALL installations. The fuel injector has a
precisely sized orifi ce to ensure only the proper
quantity of gas enters the burner. This allows
maximum performance and gas conservation.
2. When installing the log set, use Tefl on tape or
pipe compound resistant to the action of
gas on all threaded male connections except
brass to brass connections.
3. Installing the gas log set (see Fig. 6-1)
a. Attach the large adapter (Item 9a) to the gas
supply stub in the fi replace. Use Tefl on tape or
pipe compound on the stub. Tighten securely.
Connect the tubing to the adapter.
b. Attach the smaller adapter (Item 9c) to the fuel
injector on the burner pan using Tefl on tape
or pipe compound and tighten securely.
c. Connect the open end of the fl ex tubing to the
small adapter. Tighten securely.
d. Use a long-necked butane lighter, or lay a
lighted match next to the burner pipe, and
carefully turn on the gas supply until the
burner ignites.
e. Test for leaks at all connections with a soapy
water solution. Never use an open fl ame to
check for leaks.
e. Turn off gas supply.
f. Proceed to GRANULE PLACEMENT.
INSTALLATION (cont.)
GRANULE PLACEMENT
The granules supplied with the unit are specially
selected for use with natural gas. They maximize
fl ame distribution and reduce carbon buildup.
1. With the burner pan off and properly positioned
in the fi replace, fi ll the burner pan completely
with the granules. Avoid spilling the granules
on the Peterson control, if one is in place.
2. Slope the granules at the same angle as the
burner pan. This is important to ensure quiet
lighting and even fl ame distribution.
3. Pour a small amount of the granules along the
outside bottom edges and back of the burner
pan (Fig. 6-2). This prevents fl ame diversion.
Fig. 6-2
Back
wall of
fi replace
Burner pan
Granules
GLOWING EMBERS PLACEMENT
Real-Fyre
®
glowing embers are specially formulated
and sized to create the most authentic, uniform glow,
duplicating red hot coals under the grate. They are a
major element in the beautiful realism of Real-Fyre
®
gas log sets. All materials used are nonfl ammable
and inert, containing no asbestos.
1. Sprinkle the Real-Fyre
®
glowing embers lightly
and evenly over the entire surface of the
granules (Fig. 6-2). For Charred series log sets
see page 9.
GRATE REPLACEMENT
1. Reposition the grate in the fi replace over the
burner pan. Make sure the stabilizer clips slide
over the back edge of the burner pan.
Fig. 6-1 - Fireplace valve
Fuel injector
Aluminum
tubing
Hearth
elbow
BURNER
PA N
Gas
supply line
Connector
elbow