Owner`s manual
11
REV 7 - 0903130830
No. L-A2-17509
MAINTENANCE
Once installed and operating properly, the Real-
Fyre
®
gas log set requires very little maintenance.
You should inspect the log set and control annually
for the following:
1. Excessive sooting - Some sooting of the log set
is normal and adds to the appearance of burned
wood. If sooting accumulates, you may brush the
soot off with a stiff brush. Do not use water or
soot cleaners to clean off the soot.
2. Settling of glowing embers and granules -
Moisture may cause the granules and glowing
embers in the burner pan to settle and affect
the burn. Using a screwdriver or fl at blade knife,
carefully stir the granules and embers, loosening
the materials.
3. Debris around the burner - Inspect the burner
pan to be sure it is free of any debris.
SERVICE
While some minor service conditions may
be handled by the owner of the log set, it is
recommended that a qualifi ed service technician be
called to service the gas log set and burner should
service be required. The TROUBLESHOOTING
section of these instructions serves as a guide for
ensuring optimum performance of the gas log set.
FLAME DESCRIPTION
Observe the fl ames. The main burner fl ames should
be blue at the base and a combination of blue/
yellow at the body and at the tips. They should be 5"
to 8" above the logs, with the center fl ame being the
tallest. Flames in the ember burner should be
1
/
4
"
above the embers.
TECHNICAL DATA AND SPECIFICATION INFORMATION
To adjust the fl ame pattern, take a long blade screwdriver or similar tool and stir the granules until the desired
pattern is achieved. DO NOT REMOVE GRANULES FROM THE BURNER PAN
Insert blade into granules and
stir in various places until desired
fl ame pattern is achieved.
Long bladed screwdriver
(or similar)