Installation Sheet

Pleasegoto forproductcleaningtips.Gotothe selection.
(2)A19MediumBaseBulbs75WMaximum,bulbsnotincluded.
20-30minutes
Identifyandinspectallpartsbeforebeginninginstallation.Checkpackagecontentlistanddiagramsbelowtobesureallpartsare
present.Ifanypartsaremissingordamaged,donotattempttoassemble,install,oroperatethefixture.Contactyouroriginalplaceofpurchase.
www.quoizel.com Care+Maintenance
BulbRecommended:
Estimated Assembly Time:
Preparation:
ToolsRequired:None.
Warnings and Cautions
1of1
Installation Guide #IS-TFMK6325VA
For Style TFMK6325VA
Turn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if in doubt.
These instructions are provided for your safety. It is very important you read them completely before installing the fixture. We strongly
recommend that a licensed, professional electrician perform the installation.
Disconnect fixture from power source before replacing bulbs. Make sure bulbs are given sufficient time to cool before removal.
Care of Tiffany Style Shade
A new tiffany lamp shade has an oil film applied to the shade that protects the tiffany shade from scratches during shipment. If the oil applied is
too heavy you can remove the excess oil film with a paper towel. Gently wipe away the excess oil.
For general cleaning of tiffany shades use a gentle lemon oil-based furniture polish applied to a soft cloth and wipe gently.
If a white powder appears on the soldered joints of the tiffany shade this is a normal oxidation process. Use a small amount of lemon oil or
mineral oil applied directly to oxidized areas and the soldered area will return to like new.
Bulb (not
included)
TFMK6325VA
NOTE: ALL DIMENSIONS ARE ROUNDED
UP TO THE NEAREST 1/4"
Base
x1
16” SQ.
24.75”
Cord
FINISH: VALIANT BRONZE
2018 QuoizelInc.
ReleasedDate:2018-08-08
visit us on-line at www.quoizel.com
Finial
x1
Big Knurled
Nut x 1
Small
Knurled Nut
x1
Check Ring
x1
Spacer Tube
x1
Nipple with
Hex Nut
x1
Socket
Assembly
x1
8.25”
Shade
x1
A. Thread the Socket Assembly
onto the Base and hand tighten
until snug.
B. Thread the hex nut end of the
Nipple with Hex Nut into the hex
coupling on the top center of the
Socket Assembly. By using the
pliers, thread the hex nut
against the hex coupling and
hand tighten until snug.
C. Place the Spacer Tube and the
Check Ring over the top end of
the Nipple and secure with the
Small Knurled Nut. Hand
tighten until snug.
D. Thread the Big Knurled Nut
onto the top end of the Nipple
and adjust it to proper location
for rest components. Place
and the Shade over
the top end of the Nipple as
shown. M
and secure
with the Finial. Hand tighten
until snug.
E. Insert bulbs onto sockets and
screw snugly into place.
Your fixture is now assembled
and ready to use. Enjoy!
Pull the cord from
the Base as you assemble the
parts together to remove the
excess cord between parts.
the
Flat Washer
ake sure Shade are
parallel with Base
Flat Washer
x1
Incorrect
base/ socket/
shade Orientation
Correct
base/ socket/
shade Orientation
6.25” SQ.