Installation Sheet

ManualsBrandsQuoizel ManualsPendantsQuoizel Showcase 3 Light 12-1/2" Wide Multi Light Pendant

1of3

Package Contents

Crossbar Assembly

Ceiling Canopy

Wire Connectors

Safety Clip

Jumper Wires

White Wire

Black Wire

Green Wire

Pleasegoto forproductcleaningtips.Gotothe selection.

Flatheadscrewdriver,Phillipsscrewdriver,pliers,wirecutters,wirestrippers,electricaltape,safetyglasses.

MinimumHangingHeightis13”,MaximumHangingHeightis103”.

MissingParts?Contactyouroriginalplaceof

purchase.

www.quoizel.com Care+Maintenance

ToolsRequired:

LightSource:

FixtureHangingHeight:

(3)A19MediumBaseBulbs100WMaximum,MediumBaseG40VintageBulbsarerecommended,bulbsnotincluded.

EstimatedAssembly Time:

Preparation:

30-45minutes

Identifyandinspectallpartsbeforebeginninginstallation.Checkpackagecontentlistanddiagramsbelowtobesureallpartsare

present.Ifanypartsaremissingordamaged,donotattempttoassemble,install,oroperatethefixture.

Warnings and Cautions

For Style SCE2703EK

Turn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if in doubt.

These instructions are provided for your safety. It is very important you read them completely before installing the fixture. We strongly

recommend that a licensed, professional electrician perform the installation.

Disconnect fixture from power source before replacing bulbs. Make sure bulbs are given sufficient time to cool before removal.

Installation Guide #IS-SCE2703EK

2018 QuoizelInc.

ReleasedDate:2018-04-10

visit us on-line at www.quoizel.com

Fixture Body

STEP 1 Remove Ceiling Canopy from Cord-

A. Remove mounting balls on the bottom of the ceiling canopy and remove

the crossbar assembly from the ceiling canopy.

B. Remove safety clip from the cord.

C. Loosen the set screw on the coupling underside of the ceiling canopy.

Pull the cord out of the ceiling canopy completely.

D. Repeat above steps for all Fixture Bodies (F).

E. The mounting balls, crossbar assemblies, safety clips and ceiling

canopy assemblies are not required for this fixture. Please discard.

Figure 1

Safety Clip

Set Screw

Mounting Ball

Crossbar Assembly

Coupling

Cord

Ceiling Canopy

Summary of content (3 pages)

PAGE 1
Installation Guide #IS-SCE2703EK For Style SCE2703EK Please go to www.quoizel.com for product cleaning tips. Go to the Care + Maintenance selection. Tools Required: Flathead screwdriver, Phillips screwdriver, pliers, wire cutters, wire strippers, electrical tape, safety glasses. Light Source: (3) A19 Medium Base Bulbs 100W Maximum, Medium Base G40 Vintage Bulbs are recommended, bulbs not included. Fixture Hanging Height: Minimum Hanging Height is 13”, Maximum Hanging Height is 103”.
PAGE 2
Please measure the height you want to hang the pendant prior to hanging so you know what length to cut the wire. You can add 6" to that length to help adjust the shades up or down once it’s hung. Please note, all the extra wire will not fit inside the small canopy and junction box, the wire needs to be cut at the desired length to fit inside the canopy and junction box to then help adjust to the exact height. IMPORTANT: Install the cord into the ceiling canopy before cutting it to length.
PAGE 3
STEP 5 - Wire Connections SCE2703EK A. Wrap bare or green ground wire around green ground screw on the crossbar, no less than 2 inches from the end of the wire. Tighten the green ground screw. B. Use standard wire connectors (not included) to make all wire connections. Twist connectors until wires are tightly joined together. Wrap each connection with approved electrical tape and carefully stuff all the connected wires into the Outlet Box. FINISH: EARTH BLACK 11” Dia.