Installation Sheet

ManualsBrandsQuoizel ManualsPendantsQuoizel Ravenel Single Light 8" Wide Outdoor Mini Pendant with Glass Panel Shades

1of3

Assembly Instruction Sheet #IS-RNL1908WT

For Style RNL1908WT

6 CORPORATE PARKWAY

GOOSE CREEK SC 29445

www quoizel com

Package Contents

Hardware Contents

Crossbar

Lock Washer

Hex Nut

Nipple

Canopy

Chain Loop

Canopy Lock

Ring

Ceiling Canopy

Fixture Chain

Quick Link

2017 QuoizelInc.

Thank you for purchasing a Quoizel product.

Need assistance with parts or assembly? Call Quoizel customer service at 1-800-645-3184

or visit us on-line at www.quoizel.com

Fixture Loop

ReleasedDate: 2017-10-17

Warnings and Cautions

Turn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if in doubt.

These instructions are provided for your safety. It is very important you read them completely before installing the fixture. We strongly

recommend that a licensed, professional electrician perform the installation.

Disconnect fixture from power source before replacing bulbs. Make sure bulbs are given sufficient time to cool before removal.

Pleasego to forproduct cleaning tips.Goto the selection.

(1)A21Medium Base Bulb150WMaximum or

(1)Medium Base VintageBulbisrecommended but notsupplied.

30-45minutes

Identifyand inspect allparts before beginning installation.Check package contentlist and diagrams belowto ensure allparts are

present.If any partsaremissing or damaged,do not attemptto assemble, install, oroperate the fixture.Contact customer service forreplacement

parts.

www.quoizel.com Care+ Maintenance

LightSource:

EstimatedAssembly Time:

Preparation:

ToolsRequired: Flatheadscrewdriver,Phillips screwdriver,pliers, wirecutters, wire strippers,electrical tape, safety glasses.

Glass Panel

Fixture Body

STEP 1 Install Glass Panels

and Fixture Loop

A. Insert the Glass Panel (B) into

the cage. Attach the top edge of

the Glass Panel (B) to the slot in

the top of the cage. Fold tabs in

the bottom edge of the cage to

secure Glass Panels (B).

B. Thread the Fixture Loop (A) onto

the nipple on the top center of

the Fixture Body (C) and hand

tighten until snug.

Figure 1

Slot

Cage

Tab

STEP 2 Install the Crossbar to the junction box-

A. Attach the Crossbar (AA) to the Outlet Box with the head of the

Green Ground Screw facing you. Secure it with Outlet Box Screws

(not included), tighten until snug

Figure 2

Outlet Box

Outlet Box Screw

(not included)

Green Ground

Screw

STEP 3 Install the Canopy Chain Loop and Nipple-

A. Thread one Hex Nut (CC) to one end of the Nipple (DD) until it is at

least 0.25” from the end. Pass one Lock Washer (BB) over the end

of the Nipple (DD) and thread the Canopy Chain Loop (EE) onto the

Nipple (DD). By using pliers, thread the Hex Nut (CC) against the

Canopy Chain Loop (EE) and hand tighten until snug.

B. Thread another Hex Nut (CC) to the middle of the Nipple (DD).

Place another Lock Washer (BB) over the Nipple (DD) and then

thread the Nipple (DD) into the Crossbar (AA) until the Nipple (DD)

is about 0.375” above the Crossbar (AA).

C. Remove the Canopy Lock Ring (FF) from the Canopy Chain Loop

(EE). Place the Ceiling Canopy (II) over the Canopy Chain Loop

(EE) against the ceiling to determine the correct position of the

Nipple (DD). Thread the Canopy Lock Ring onto the Canopy Chain

Loop (EE). Adjust the Nipple (DD) to allow the Ceiling Canopy (II) to

Summary of content (3 pages)

PAGE 1
Assembly Instruction Sheet #IS-RNL1908WT For Style RNL1908WT 6 CORPORATE PARKWAY GOOSE CREEK , SC . 29445 www . quoizel . com Please go to www.quoizel.com for product cleaning tips. Go to the Care + Maintenance selection. Tools Required: Flathead screwdriver, Phillips screwdriver, pliers, wire cutters, wire strippers, electrical tape, safety glasses. Light Source: (1) A21 Medium Base Bulb 150W Maximum or (1) Medium Base Vintage Bulb is recommended but not supplied.
PAGE 2
(Step 3 Continued) STEP 5 - Making the Wire Connections rest against the ceiling when held in place by the Canopy Lock Ring (FF). D. Remove the Canopy Lock Ring (FF) and the Ceiling Canopy (II). Tighten the Hex Nut (CC) against the Crossbar (AA) to secure in place. BB CC AA Step B DD A. Wrap bare or green ground wire around green ground screw on the crossbar, no less than 2 inches from the end of the wire. Tighten the green ground screw. B.
PAGE 3
RNL1908WT NOTE: ALL DIMENSIONS ARE ROUNDED UP TO THE NEAREST 1/4" FINISH: WESTERN BRONZE 5"x5" 121.75” OVERALL HEIGHT ( INCLUDES 96” CHAIN AND 2 QUICK LINKS ) 20" 8"x8" 2017 QuoizelInc. Thank you for purchasing a Quoizel product. Need assistance with parts or assembly? Call Quoizel customer service at 1-800-645-3184 or visit us on-line at www.quoizel.