Installation Sheet

1of2
For Style PCHS2816C
Installation Guide IS-PCHS2816C#
Pleasegoto forproductcleaningtips.Gotothe selection.
Flatheadscrewdriver,Phillipsscrewdriver,pliers,wirecutters,wirestrippers,electricaltape,safetyglasses,markingpen,1/4”
drillbitanddrill.
LED20W
MinimumHangingHeightis14”,MaximumHangingHeightis105.5”.
Contactyouroriginalplaceofpurchase.
www.quoizel.com Care+Maintenance
ToolsRequired:
LightSource:
FixtureHangingHeight:
EstimatedAssemblyTime:
Preparation:
30-45minutes
Identifyandinspectallpartsbeforebeginninginstallation.Checkpackagecontentlistanddiagramsbelowtobesureallpartsare
present.Ifanypartsaremissingordamaged,donotattempttoassemble,install,oroperatethefixture.
Warnings and Cautions
Turn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if in doubt.
These instructions are provided for your safety. It is very important you read them completely before installing the fixture. We strongly
recommend that a licensed, professional electrician perform the installation.
E
STEP 1 Attach Crossbar Assembly to Outlet Box-
A. Attach the Crossbar Assembly (A) onto the outlet box and make two
marks on the ceiling from a set of slot holes.
Supply Wires with
Ground Wire
Outlet Box Screw
(not included)
Outlet Box
2018 QuoizelInc.
ReleasedDate:2018-08-15
visit us on-line at www.quoizel.com
Package Contents
B
Crossbar
x1
Assembly
A
Fixture Body
x1
GND
F
Wall Anchor
x2
C
Screw
x2
Washer
x2
D
Small Cracked Glass
x3
G
Big Cracked Glass
x3
Figure 1
A
B
C
D
Slot Hole
(Step 1 Continued)
B. Remove the Crossbar Assembly (A). Using a 1/4” drill bit, drill holes
at each (2) locations marked on the ceiling.
C. Insert Wall Anchors (B) into drilled holes completely.
D. Pass supply wires and ground wire through the center hole of the
Crossbar Assembly (A). Attach the Crossbar Assembly (A) to outlet
box. Thread outlet box screws (not included) into mounting holes on
the outlet box. Pass Washers (D) over Screws (C) and thread
Screws (C) into Wall Anchors (B). Hand tighten until snug with
screwdrivers.
STEP 2 Adjust Fixture
Height
-
A. Press each button on the
bottom of the ceiling canopy
and adjust each cord in or
out of the ceiling canopy to
achieve your desired socket
height.
B. Move safety clips next to the
hex nut inside of the ceiling
canopy.
Ceiling Canopy
Button
Safety Clip
Cord
Figure 2
Socket